wbuart32 VS zbasic

I have built a lot of open-source C++ tooling for design verification. You can find a lot of my C++ models posted on my Github. Example C++ models include: UART, SPI/DSPI/QSPI Flash, SD-Card (SPI-based interface), VGA Video, Ethernet MDIO, PS/2 mouse, OLED display, SDRAM and more. (I've even simulated PLLs using C++ models ...) I have also written extensively about doing so at ZipCPU.com.

Try this one.

For example, some time after I built my own first serial port transmitter and receiver, someone tried using them in composition: A host (i.e. PC) would transmit a bunch of data, get received by the FPGA, processed by the receiver, and then the data would be sent back to the host via the transmitter. This is a hard test to get right, and my own design failed at the task. (It only returned every other byte!) What I learned from this is that the transmitter must take exactly (10*BAUD_CLOCKS) to transmit a byte. That also means that READY must be high on the last clock cycle of the byte to avoid falling behind. Let's just say that my own serial port wasn't (initially) up to the task. Among other things, the serial port receivers output "VALID" was only one cycle long, and didn't get latched anywhere if the transmitter wasn't ready for it. As I recall, we spent many days scratching our heads at the problem. Eventually, the person using my FPGA switched his host to sending 2-stop bits and things started working. Later, and only a long time later, did I ever find the off-by-one bug in the STOP bit state. My point? Serial port composition is an exacting test, and therefore a good one to work with. You ought to try it.

The core component to the single simulated to TCP port can be found here, in uartsim.cpp. You can find a companion software program that will forward the same TCP port to a hardware serial port here, under the name netuart.cpp.

Here's sort of a generic repo you can look at which might give you some ideas.

Let me also point out that I rarely use Verilators -exe flag. I tend instead to build my designs in steps: 1) Run Verilator, 2) run make -f Vtoplvl.mk in the obj_dir directory, 3) turn my test script into an object file, and only then 4) link everything together into an executable. I've also been known for peeking at Verilator's internal variables during a simulation run--but that may be another topic entirely.

As examples: - Here's how I process libelf to provide me with an array of section pointers, each containing the address to load the values at - Here's where I then load the values into my design when I'm using an external loader via a debugging bus. - Here's another copy of the same, this time running from within Verilator rather than from within externally controlled logic.

The components found in ZBasic will split the stream into two. The key files you'll want there are dbluartsim.cpp and (again) netuart.cpp. To use dbluart, you'll need three pieces: First, you'll need to call setup() to set the baud rate, then once per clock cycle you'll want to call the operator() method--which is really just a rename for the tick() method.