makani VS ODrive

- https://github.com/google/makani/ (Bazel, C, testing, architecture, real-time control, code-generation)

I'd say it's very different with X. I looked at the large number of hardware design docs that was open-sourced[1] when they shut down Makani - hell, even the Makani documentary[2] was mostly about hardware (material science, mechanics, aerodynamics) with a some software sprinkled in.

1. https://github.com/google/makani

2. https://www.youtube.com/watch?v=qd_hEja6bzE

But it's great that they released everything as open source, I didn't know that, that's awesome. Anybody wanna build a kite?

ODrive perhaps?

Well I dunno, maybe see how ODrive does it

Then maybe just hook everything to an Odrive and maybe add an Arduino or something to tell it what to do - although this also means you'll probably want an encoder at least on the pedalling motor to get accurate position/speed readings at low speed, since pedalling cadence is typically in the 60-90RPM range

If you want speed, use servomotors

This video may interest you, maybe also check this one and check out simpleFOC and/or ODrive

ODrive time?

Look at using some RC brushless motors driven from an ODrive board

You can probably replicate your own with appropriately sized RC brushless motors driven from ODrive boards. The boards can be linked together via CAN bus to communicate with your Arduino equipped with a CAN bus shield.

Thanks for the link! I know about simplefoc, the problem is the hardware. Simplefoc focuses on low wattage motors, e.g. a gimbal motor for a camera. For high wattage application, there's not much hardware available, and none that is affordable. There's odrive, which will set you back ~300$ just for the controller. Other than that, you'll have to go to traditional robotics companies.