esp32-doom VS doom-nano

Since it looks to be built on the ESP32 platform, the answer is likely yes (but you'd need a display...) https://github.com/espressif/esp32-doom

I think actually there are a couple of DOOM ports for the platform.

My most pressing question is, can it play Doom?

There seems to be a port for ESP32 [0] and Arduino Nano does play it [1], so maybe?

[0]: https://github.com/espressif/esp32-doom

[1]: https://m5stack.hackster.io/naveenbskumar/yes-arduino-nano-e...

Perhaps try this: https://github.com/espressif/esp32-doom

should be fine, yeah

There is a port of DOOM for an ESP32, proving that it can be done, however I have added additional constraints on myself as follows:

Now all we need for DOOM everywhere is to make the memory management more portable. It's still difficult to port DOOM to microcontrollers like the ESP32 and ARM Cortex-M and RISC-V, which are easily fast enough to run it but which have much less RAM than a 90's PC (128-512K vs 4MB). But they can use external RAM via SPI which is very cheap for 4 or 8 MB, and while that is slower than 90's DRAM because of the serial protocol it should be good enough with a very simple cacheing strategy?

how do i put this (https://github.com/daveruiz/doom-nano) to arduino ide or is it even possible

he probably used this code

At this moment it's not playable (yet). I'm basing myself on the Doom nano project (https://github.com/daveruiz/doom-nano/tree/234640478b38f16558b34b543ef6ff14b72e3fb2) which is not the actual Doom game but rather a raycasting engine using Doom sprites, need to find the time to continue my progress :)

You need to have at least a 128x64 display. If you have a pro-micro based microcontroller I'm pretty sure that you wont be running real doom. You can try to port this code

Yes, https://github.com/daveruiz/doom-nano did a really amazing job in making a kinda doom running on atmega328, 3d rendering engine using just 1 kb of RAM (another 1 kb is needed as screen buffer) is mind-blowing

"To be clear. This is not an actual Doom game, just picked some sprites from it (and simplified a lot). The rendering engine is more like a Wolfeistein 3D." - https://github.com/daveruiz/doom-nano

look what Google found

Ok so I wanna try this project where this person managed to run doom using an Arduino Uno. The video I saw was this https://www.youtube.com/watch?v=Qbt8HpTPRSY. The video also mentioned the original creator of this project and the source code is available here https://github.com/daveruiz/doom-nano. I am only confused as to how to arrange this in the compiler. Since I won't be using resistors as the page mentions how to use an internal pull-up resistor by editing one of the library files. Please help.