FanControl.Releases VS nbfc

You don't really need PID, just a decent fan curve with https://github.com/Rem0o/FanControl.Releases

I think you're looking for FanControl https://github.com/Rem0o/FanControl.Releases There is a bit of initial setup but nothing crazy, and it guides you through with a nice and clean UI. Once you're in, you can set your fan curve and all the smaller details if you want, like how long will the fans take to spin up or spin down, or how long to delay a speed change after hitting a certain temperature threshold so that its not constantly revving up and down

You could even replace all the fans with Noctua nf a12s and control using this and still have saved money: https://github.com/Rem0o/FanControl.Releases

MSI Afterburner should work for gpu fans. Motherboards typically have their own version of software for fan control, so you could use that (dl from mfg website), or there's this one that I know of that should work for any mobo (although there's probably others): https://github.com/Rem0o/FanControl.Releases

If your fans are heywire, draining your bats download fan control. Works great.https://github.com/Rem0o/FanControl.Releases

I've seen a lot of reccs pointing to https://github.com/Rem0o/FanControl.Releases if you don't want to stick with your BIOS to control fans.

Being a Corsair PSU, you might be able to control the fan curve with this open source fan software

This app relatively the same feature, but is not open source and run only on Windows

The only other thing I can think of is https://github.com/hirschmann/nbfc

Try Notebook FanControl. There's a config profile for GL702VM included.

Non tinkerer answer: no Otherwise: Maybe, specially if you are a programmer, take a look at this project https://github.com/determ1ne/OmenHubLight (it supposedly supports four zones rgb and fan control), or this one https://github.com/alou-S/omen-fan which is for linux, but should give you an idea of what has to be done and maybe port it to windows using ec-probe utility from https://github.com/hirschmann/nbfc, and last but not least the hp-wmi linux driver https://github.com/torvalds/linux/blob/master/drivers/platform/x86/hp/hp-wmi.c which has some of the gaming hub features ported.

As a person that still uses Linux on my laptop (its an old gaming laptop I use as a server) I know your pain about fan control, on windows you have many functional fancontrol software but on Linux it's crickets I did find this utility that worked for my laptop but it took over 3 hours for me to figure out how it worked and properly configure it for my specific gaming laptop

There are hacky ways like NBFC here: https://github.com/hirschmann/nbfc This tool works by writing embedded controller registers directly. This can work for some laptops but has its own danger to it.

To depress just yet, fortunately, there is a very nice, open-source windows tool that can be used to control a laptop fans: NOTEBOOK FAN CONTROL

You have access to the fan curves only thru Armoury Crate's manual mode . I haven't personally tried this but there was an app called "notebook fan control", it might be helpful . I used to run it on my GL502VY laptop back in the day where it was kinda impossible to change the fan speeds. You can find it on github