SaaSHub helps you find the best software and product alternatives Learn more →
VoronUsers Alternatives
Similar projects and alternatives to VoronUsers
-
InfluxDB
Power Real-Time Data Analytics at Scale. Get real-time insights from all types of time series data with InfluxDB. Ingest, query, and analyze billions of data points in real-time with unbounded cardinality.
-
Voron
This repository contain files related to modifications or experimentations I performed on parts of 3D Printers designed by the Voron team
NOTE:
The number of mentions on this list indicates mentions on common posts plus user suggested alternatives.
Hence, a higher number means a better VoronUsers alternative or higher similarity.
VoronUsers reviews and mentions
Posts with mentions or reviews of VoronUsers.
We have used some of these posts to build our list of alternatives
and similar projects. The last one was on 2022-09-16.
-
Probe comparison
I use a CR Touch with the CR Shell Mod and a modified MGN-12 SB carriage so that it fits in the stock probe slot. Started with unklicky-NG for a bit, but had too many issues with the dock flexing just enough during high temp prints that it wouldn't mount successfully unless I let everything cool down between prints.
-
How does one know what is the best configuration to build?
I went with the Stealthburner with CW2 instead of the AB with CW1. I also did CAN and went with the EBB36. I had planned to do the normal cable chains, but ended up switching to an umbilical for the extruder and chain for the Y (endstop board). I also did the AB Idler mod as I've seen a lot of people post problems with the stock one splitting at the tension bolt. I also did not use the stock induction sensor and went with a CR-Touch. The CR Touch mod does require a modifcation to the single MGN-12 carriage. I have my modified STLs/F3D files if you're interested. I had the klicky (unklicky) mod for a while but had issues with heat causing the gantry mount to shift ever so slightly where I had mounting problems when warm. I've got about 150 hours of printing on the CR touch so far with no issues. I also did the purge/wipe bucket as well. At some point, I will likely do the pin mod and change the umbilical mod to this one and relocate the X endstop the print carriage and Y endstop the A drive mount. I also swapped out the door hinges after a few hours.
-
Ender 3 V2.. need hotend recommendations.
I'm planning on using the Afterburner by Voron Design that is on their 2.4r2 build (STLs here), with this mod to allow me to still use my CR touch.
-
A note from our sponsor - SaaSHub
www.saashub.com | 4 May 2024
Stats
Basic VoronUsers repo stats
3
10
2.6
over 2 years ago
dennistimmermann/VoronUsers is an open source project licensed under GNU General Public License v3.0 only which is an OSI approved license.
The primary programming language of VoronUsers is GAP.
Sponsored
SaaSHub - Software Alternatives and Reviews
SaaSHub helps you find the best software and product alternatives
www.saashub.com