Stealthburner-Umbilical-mod Alternatives

Similar projects and alternatives to Stealthburner-Umbilical-mod

VoronUsers

347 2,863 8.8 OpenSCAD Stealthburner-Umbilical-mod VS VoronUsers

Voron Community mods
Voron-2-Mods

13 366 0.0 Stealthburner-Umbilical-mod VS Voron-2-Mods

Discontinued All my mods at one place
InfluxDB

www.influxdata.com featured

Power Real-Time Data Analytics at Scale. Get real-time insights from all types of time series data with InfluxDB. Ingest, query, and analyze billions of data points in real-time with unbounded cardinality.
VoronMods

7 126 0.0 Stealthburner-Umbilical-mod VS VoronMods

Mods I have created for my Voron printer (by kejar31)
VoronUsers

3 10 2.6 GAP Stealthburner-Umbilical-mod VS VoronUsers

Voron Community mods, slicer profiles and firmware configurations. (by dennistimmermann)

NOTE: The number of mentions on this list indicates mentions on common posts plus user suggested alternatives. Hence, a higher number means a better Stealthburner-Umbilical-mod alternative or higher similarity.

Suggest an alternative to Stealthburner-Umbilical-mod

Stealthburner-Umbilical-mod reviews and mentions

Posts with mentions or reviews of Stealthburner-Umbilical-mod. We have used some of these posts to build our list of alternatives and similar projects. The last one was on 2022-09-16.

How does one know what is the best configuration to build?
7 projects | /r/VORONDesign | 16 Sep 2022

I went with the Stealthburner with CW2 instead of the AB with CW1. I also did CAN and went with the EBB36. I had planned to do the normal cable chains, but ended up switching to an umbilical for the extruder and chain for the Y (endstop board). I also did the AB Idler mod as I've seen a lot of people post problems with the stock one splitting at the tension bolt. I also did not use the stock induction sensor and went with a CR-Touch. The CR Touch mod does require a modifcation to the single MGN-12 carriage. I have my modified STLs/F3D files if you're interested. I had the klicky (unklicky) mod for a while but had issues with heat causing the gantry mount to shift ever so slightly where I had mounting problems when warm. I've got about 150 hours of printing on the CR touch so far with no issues. I also did the purge/wipe bucket as well. At some point, I will likely do the pin mod and change the umbilical mod to this one and relocate the X endstop the print carriage and Y endstop the A drive mount. I also swapped out the door hinges after a few hours.
What gauge wire do I need if I want to run some extra wires to the printhead?
1 project | /r/VORONDesign | 18 Aug 2022

Yes. One of the EBBs and the U2C. If you're running a Stealthburner, I personally prefer this mod: https://github.com/Markus-1984/Stealthburner-Umbilical-mod.