pisugar-case-pihat-cap VS LCD-show

the problem here is im so confused which files I need to send to that 3d print service to have them make the case. the link is this, I assume that the STL files here are what I need so I can used it with the HAT, the problem is, it missing the part which is the case it self that holds everything, and the rest of the part is found here which is I dont know what the other STL files I needed here that is compatible with the first link. One thing I noticed here is that some of the STL files can accommodate battery? But I dont need that so just a ordinary case that can hold everything which is the pi zero w and the 1.3inch oled hat.

Hat Cap : https://github.com/PiSugar/pisugar-case-pihat-cap

I looked into the GitHub project and followed their steps as well just in case the other one was outdated, but ran into the same issue. And googling isn’t very help since anything along the lines “raspberry pi 5 lcd screen issue/driver” just returns a bunch of results for 5” screens.

That repo is full of pretty janky scripts, but I'd look at their system_restore script: https://github.com/goodtft/LCD-show/blob/master/system_restore.sh

The code changes /boot/config.txt to set the monitor driver and screen size (lines 22-32 in the code).

sudo rm -rf LCD-show git clone https://github.com/goodtft/LCD-show.git chmod -R 755 LCD-show cd LCD-show/ sudo ./LCD35-show

The driver for the display apparently breaks libcamera;

How can I get the WaveShare 3.5 inch TFT display to work on my raspy 4B that is running Manjaro. It works fine using the https://github.com/goodtft/LCD-show drivers in Raspbian which is based on Debian, but it doesn't work on Arch-based Manjaro. I tried this attempt at a port but it didn't work for me: https://github.com/Bennett-Wendorf/LCD-show/tree/arch-compatibility-part-2 Any hope on manjaro?

The supplied information here references https://github.com/goodtft/LCD-show.git as the repository to use for the display , this particular one uses "LDC28-show" but the repository works with all sorts of generic displays. after following the instructions and rebooting my screen either remind white or grey.

The library is the next: https://github.com/goodtft/LCD-show/blob/master/LCD5-show , at 18 line the I2C is enable, at line 21 the display is rotate, but I don´t see how is send the data through the I2C. That line save the data in file "boot/config.txt", but I don´t found how is used to send data over the I2C port.

Okay. I'll give that a shot in lieu of https://github.com/goodtft/LCD-show.git for #3, but thanks for your help on 1, 2, 4.

git clone https://github.com/goodtft/LCD-show.git