LCD-show VS noobs

I looked into the GitHub project and followed their steps as well just in case the other one was outdated, but ran into the same issue. And googling isn’t very help since anything along the lines “raspberry pi 5 lcd screen issue/driver” just returns a bunch of results for 5” screens.

That repo is full of pretty janky scripts, but I'd look at their system_restore script: https://github.com/goodtft/LCD-show/blob/master/system_restore.sh

The code changes /boot/config.txt to set the monitor driver and screen size (lines 22-32 in the code).

sudo rm -rf LCD-show git clone https://github.com/goodtft/LCD-show.git chmod -R 755 LCD-show cd LCD-show/ sudo ./LCD35-show

The driver for the display apparently breaks libcamera;

How can I get the WaveShare 3.5 inch TFT display to work on my raspy 4B that is running Manjaro. It works fine using the https://github.com/goodtft/LCD-show drivers in Raspbian which is based on Debian, but it doesn't work on Arch-based Manjaro. I tried this attempt at a port but it didn't work for me: https://github.com/Bennett-Wendorf/LCD-show/tree/arch-compatibility-part-2 Any hope on manjaro?

The supplied information here references https://github.com/goodtft/LCD-show.git as the repository to use for the display , this particular one uses "LDC28-show" but the repository works with all sorts of generic displays. after following the instructions and rebooting my screen either remind white or grey.

The library is the next: https://github.com/goodtft/LCD-show/blob/master/LCD5-show , at 18 line the I2C is enable, at line 21 the display is rotate, but I don´t see how is send the data through the I2C. That line save the data in file "boot/config.txt", but I don´t found how is used to send data over the I2C port.

Okay. I'll give that a shot in lieu of https://github.com/goodtft/LCD-show.git for #3, but thanks for your help on 1, 2, 4.

git clone https://github.com/goodtft/LCD-show.git

Is there any way you can access the terminal? Like does it take you to the login screen at all? If so, you can mount a different SD card partition (try to mount /dev/mmcblk0p5/ or /dev/sda1/), reboot, and it should work (only if you somehow mounted the recovery partition by accident). This page may be helpful for you in understanding the partition issue and finding which partition to mount if it’s not one of those two above.

The secondary reason I advise against NOOBS is that it has been removed from the downloads page (see here for the GITHUB repository) - the primary is that it does give issues with updates / upgrades and gets in the way. It's much simpler to use a 16Gb or 32Gb card given the way the costs have dropped.

https://github.com/raspberrypi/noobs/issues/634 all the way back in 2021

First off, what do we need? - A Raspberry Pi (a Raspberry Pi 3 Model B V1.2 in my case) - A SD-Card reader/writer - Raspberry Pi Imager software - CODESYS - CODESYS Control for Raspberry Pi MC (SL) or No SL - Factory IO (Ultimate or Modbus OPC edition)

start4.elf is not compatible USB-MSD boot requires newer software Get the latest software from https://www.raspberrypi.org/downloads.

Noobs from RaspberryPi can easily be modified like changing the logo Here is a link to the github repository: noobs

a. Download Raspian and upload it to your SD card using Balena Etcher.