LCD-show VS PiSugar

I looked into the GitHub project and followed their steps as well just in case the other one was outdated, but ran into the same issue. And googling isn’t very help since anything along the lines “raspberry pi 5 lcd screen issue/driver” just returns a bunch of results for 5” screens.

That repo is full of pretty janky scripts, but I'd look at their system_restore script: https://github.com/goodtft/LCD-show/blob/master/system_restore.sh

The code changes /boot/config.txt to set the monitor driver and screen size (lines 22-32 in the code).

sudo rm -rf LCD-show git clone https://github.com/goodtft/LCD-show.git chmod -R 755 LCD-show cd LCD-show/ sudo ./LCD35-show

The driver for the display apparently breaks libcamera;

How can I get the WaveShare 3.5 inch TFT display to work on my raspy 4B that is running Manjaro. It works fine using the https://github.com/goodtft/LCD-show drivers in Raspbian which is based on Debian, but it doesn't work on Arch-based Manjaro. I tried this attempt at a port but it didn't work for me: https://github.com/Bennett-Wendorf/LCD-show/tree/arch-compatibility-part-2 Any hope on manjaro?

The supplied information here references https://github.com/goodtft/LCD-show.git as the repository to use for the display , this particular one uses "LDC28-show" but the repository works with all sorts of generic displays. after following the instructions and rebooting my screen either remind white or grey.

The library is the next: https://github.com/goodtft/LCD-show/blob/master/LCD5-show , at 18 line the I2C is enable, at line 21 the display is rotate, but I don´t see how is send the data through the I2C. That line save the data in file "boot/config.txt", but I don´t found how is used to send data over the I2C port.

Okay. I'll give that a shot in lieu of https://github.com/goodtft/LCD-show.git for #3, but thanks for your help on 1, 2, 4.

git clone https://github.com/goodtft/LCD-show.git

I've updated the Firmware of my PiSugar3 to Version 1.3.4 by using the script found in the wiki

I have the stl files from Pi Sugar's github, a lack of 3d printing knowledge, and a dream. Someone local would be preferred but I also don't mind paying for shipping.

The software is (here) [GitHub]

Which part is giving you trouble? Did you get it setup at least? Can you access the web interface? There's an option under "Schedule Wake Up" called "On Power Restore." My understanding (although I've never used this option) is that it will turn on the Pi when the battery detects power. If it's not working, I found this: https://github.com/PiSugar/PiSugar/issues/59 which might help.

this thing?

Now, I wanted to run the PiSugar power management software so I followed the official instructions.

There is a case on pisugar GitHub, but the LED indicators holes are kinda useless... I solved it with transparent filament so it's see through. https://github.com/PiSugar/PiSugar

The 3D model is available (bat5000.SLDPRT) here https://github.com/PiSugar/PiSugar/tree/master/model_pro but you'll then need to convert it to STL to get the measurements. There are online & downloadable tools to do that. Once it's in STL format, open it with the default Microsoft 3D Builder to get al the dimensions