ethstaker.tax VS pfSense

You are probably looking for https://ethstaker.tax/ which was formerly called eth2.tax.

I’m hoping to add Rocketpool support to ethstaker.tax this year, that should hopefully help people with this.

If ethstaker.tax has helped any stakers in here figure out their staking income, I'd very much appreciate if you would donate, during the matching round even a 1$ contribution can make a big difference.

Another option is https://ethstaker.tax

Maybe ethstaker.tax (previously called ETH2.tax) ?

I just updated ethstaker.tax yesterday to account for withdrawals. They are now available in a separate column in the CSV file so you can use the "withdrawals" column and ignore the "consensus layer income" column if you wish to.

https://ethstaker.tax/ is another site that may be useful.

Hey, author of (ethstaker.tax)[https://ethstaker.tax] here. The website should be able to handle any blocks that you propose, not just ones with MEV. As long as your validator is the block proposer you should see the income there. Did you run into a case where that wasn’t true? If so please let me know. Feel free to dm me to protect your privacy.

One option is Firewalla Gold Plus, or you could buy a mini PC like it and run pfSense/OPNsense yourself.

Download and install pfsense as a virtual machine or partition: https://www.pfsense.org Configure it with the rules you want: https://youtu.be/VAGFGppSt74 Play with it, but be careful because it will block all traffic unless you check everything properly.

Another option is Firewalla, or buy a mini PC like it and run pfSense/OPNsense yourself. Two similar concepts, with the cost being either money or your DIY time. A lot of Firewalla users say that it's much easier for home use than pfSense/OPNsense, so you might find it worthwhile to spend a little more on it upfront and have to tinker less.

If you want firewall, I think you can use https://www.pfsense.org/ or https://opnsense.org/ , maybe running on an old PC or a Raspberry Pi. Not sure.

I've recently started using OPNsense. It's similar to pfSense, but seems to be considered a little more user-friendly.

For most router issues, I recommend people always put them in to dumb bridge mode and put a proper firewall like pfsense or opnsense as your gateway.

I have found that my historical average packet loss is about 0.02%. Something distinctly changed around 4/20 of this year, and now the average packet loss has gone up to 0.05% with spikes even higher, associated with periods of elevated ping times. It rarely did that before. Typically the IPv6 stack has more problems than v4 (especially an incident of packet loss on 4/28), and neither has been trouble-free since I started service in early 2020. My data comes from a pfSense installation.

I have done this using the Pfsense