dotbot VS dotter

Many command line programs keep their configurations somewhere under $HOME. These are often called "dotfiles".

If you ever use more than one machine, likely you'll want the same configuration available on all those machines.. so you'll want some way to copy them to a new machine.

Some dotfile managers are quite simple, like dotbot. https://github.com/anishathalye/dotbot

Home Manager from the Nix community is a bit more sophisticated. It allows for writing configurations in the Nix language, which is nice if you know/like Nix. (Nix is a powerful/expressive package manager. Nix is to apt-get what vim is to notepad).

I started using DotBot a couple of years ago and love it. I store my git repo at ~/.dotfiles, and DotBot handles the symlinking and everything

Dotbot (https://github.com/anishathalye/dotbot) has worked extremely well for me. It’s simple to setup, has minimal dependencies, and it is also easy to run arbitrary commands if I want to get tricky with things. I would highly recommend it.

You might also like something like https://github.com/anishathalye/dotbot. I manage all of the config I care about with this, as part of a repo that also gives me all of the other system setup and customization I expect in my environment.

With dotbot in my GitHub-repository

| for vertical split, - for horizontal split: easy to remember. I have lots of things in my config file, so I don't have an issue with a bit more customization. Installing my .tmux.conf is easy because I use the dotbot dotfile manager.

I use dotbot to manage my dotfiles, which is good for anything I need to install prior to installing plugins (I use vim-plug).

I'm glad you asked! There are plenty of dotfiles managers out there, like chezmoi, Dotbot, or yadm (you can see a list here and a comparison table (from chezmoi, thus biased) here. But for this tutorial (and my dotfiles), I chose dotter.

dotbot is fine.

dotter-rs -- config manager with templates

I was unhappy with existing solutions, especially I wanted the ability to handle differences between machines. So I built my own! You're welcome to see if you like it :)

https://github.com/SuperCuber/dotter

I'm glad you asked! There are plenty of dotfiles managers out there, like chezmoi, Dotbot, or yadm (you can see a list here and a comparison table (from chezmoi, thus biased) here. But for this tutorial (and my dotfiles), I chose dotter.

Or you could use the greatest bestest dotfile manager ever invented by yours truly - Dotter! It is designed to allow for per-machine configuration exactly like this :)

Shameless plug time! Check out my project Dotter :D

Apparently I get that a lot :P