docker-traefik-cloudflare-companion VS pfSense

II don’t think this exists for NPM but I use Traefik with https://github.com/tiredofit/docker-traefik-cloudflare-companion which creates DNS entries automatically and Flame dashboard with Docker integration (https://github.com/pawelmalak/flame) which adds new services automatically in my dashboard.

For my reverse proxy I am using Traefik 2 with Authelia as my 2 factor authentication. It works with TOTP and my YubiKey. to compliment this when I add the correct labels to my compose snippet for the respective service, tiredofit's cloudflare traefik companion container will use my cloudflare API key to update my cname records to reflect the subdomain based off my traefik labels. All of my docker containers use docker secrets for important environment variables.

try this https://github.com/tiredofit/docker-traefik-cloudflare-companion

While not sorting the wildcard issue, you can take some of the pain out of it with this: https://github.com/tiredofit/docker-traefik-cloudflare-companion

One option is Firewalla Gold Plus, or you could buy a mini PC like it and run pfSense/OPNsense yourself.

Download and install pfsense as a virtual machine or partition: https://www.pfsense.org Configure it with the rules you want: https://youtu.be/VAGFGppSt74 Play with it, but be careful because it will block all traffic unless you check everything properly.

Another option is Firewalla, or buy a mini PC like it and run pfSense/OPNsense yourself. Two similar concepts, with the cost being either money or your DIY time. A lot of Firewalla users say that it's much easier for home use than pfSense/OPNsense, so you might find it worthwhile to spend a little more on it upfront and have to tinker less.

If you want firewall, I think you can use https://www.pfsense.org/ or https://opnsense.org/ , maybe running on an old PC or a Raspberry Pi. Not sure.

I've recently started using OPNsense. It's similar to pfSense, but seems to be considered a little more user-friendly.

For most router issues, I recommend people always put them in to dumb bridge mode and put a proper firewall like pfsense or opnsense as your gateway.

I have found that my historical average packet loss is about 0.02%. Something distinctly changed around 4/20 of this year, and now the average packet loss has gone up to 0.05% with spikes even higher, associated with periods of elevated ping times. It rarely did that before. Typically the IPv6 stack has more problems than v4 (especially an incident of packet loss on 4/28), and neither has been trouble-free since I started service in early 2020. My data comes from a pfSense installation.

I have done this using the Pfsense