VoodooPS2 VS X230-Hackintosh

Keyboard and mouse nipple - VoodooPS2Controller

VoodooPS2Controller (For the trackpad it has to be modified) Look at the guide

I use Itwlm/AirportItwlm v2.1.0 and VoodooPS2Controller v2.2.9 (haven't gotten around to updating).

Keyboard (VoodooPS2), TouchPad (w/gestures) and TrackPoint (VoodooSMBus)

Questions/Basic Troubleshooting - Did you determine which type/hardware/rev your Touchpad is? Did you check in the BIOS if it's actually HID, or PS/2? You stated HID, but I see a kext entry for VoodooPS2Trackpad as well. Did you read the guide over on the VoodooPS2 page?. You may or may not have to edit the config inside the VoodooPS2Trackpad.Kext (hardware dependent, and not always necessary as of 2.28). Read carefully, there are known issues with Trackpad Gestures. Do you also have a Touchscreen as well, and is it working? (I see Voodooi2c, assuming there's no other i2c devices) Did you do Clean Snapshot after loading your Kexts/ACPI?? OCValidate?

I also tried VoodooPS2 without success.

you need to add voodoops2 kext to EFI Kext folder https://github.com/acidanthera/VoodooPS2/releases

I've seen https://github.com/acidanthera/VoodooPS2 but it only works on Hackintosh's I think? I tried installing the ktext on my genuine Macintosh but to no avail.

Currently using acidanthera / VoodooPS2

Try to follow these instructions (link1, link2). Updating from Big Sur is better method, also you should disable SIP in recovery mode before updating. And it works pretty well on my X230 (should work on other laptops too). Only main disadvantage of this patching I can't re-enable because it's breaking my installation.

It's a bit tricky, but it's possible to get it work. You can try follow these two instructions (link1, link2). I tried it on my X230 (I think it also applies to other laptops) and Monterey works pretty well (except I have to have SIP disabled).

Used this guide, a few tweaks here and there, but overall, perfect! Just make sure to read all the read me's - they fix tons of issues

Yes, first go take a look to r/hackintosh second, spend the necessary time to understand a little bit about OpenCore and you can take a look to the existing configuration like here or here

Hi everyone! So I managed to install MacOS Big Sur on a Lenovo G50-70 using OpenCore before. Now, I'd like to do the same on a Thinkpad x230 I found for cheap on Ebay. I'm using the EFI provided on this github page: https://github.com/banhbaoxamlan/X230-Hackintosh

I’ve installed hackintosh successfully for my x230 thinkpad using this GitHub repo. There is one annoying thing that I couldn’t fix every boot before opencore start I get this Log error. Is there a fix for that? Thanks

What files/config I am using: Conf Based on this - Last 8 Kernel Panic logs - My EFI folder

I made it myself but I DID use this as a reference, so mine looks quite similar.