DGUS-reloaded-Klipper VS DGUS-reloaded-Klipper-config

The stock screen needs this klipper fork and their screen firmware https://github.com/Desuuuu/DGUS-reloaded-Klipper

I have the stock screen install currently. While it works with a modified version of Klipper (https://github.com/Desuuuu/DGUS-reloaded-Klipper), that release is 2-3 years old now. I use vanilla Klipper so that I can can stay up to date with the latest releases. I don't find much use to a screen because my computer is near my printer and I just use Fluidd (or Mainsail, or Octoprint, etc.).

I’m running it on all three of mine. It works well. There is nice firmware for the screen available from Desuuuu on GitHub. https://github.com/Desuuuu/DGUS-reloaded-Klipper

.https://github.com/Desuuuu/DGUS-reloaded-Klipper

There is an old, now quite outdated, attempt at supporting the Ender 3 v2 touchscreen on Klipper through a fork. But that has not been updated in quite a while and it never really worked well enough to actually use in the first place. I strongly recommend you don't try to use that fork, but if you do you will need to recompile and re-flash the firmware as it uses an older version of Klipper. Again, this has not been updated in over a year. Do not try to use it.

With klipper i use https://github.com/Desuuuu/DGUS-reloaded-Klipper Shows temperatures and progress, i like it.

I found https://github.com/Desuuuu/DGUS-reloaded-Klipper-config/blob/master/base/creality-cr10spro.cfg Does anyone know if this would work for my v1 pro?

I found This like that matches my setup and updated my printer.cfg so the sensor pin is mapped to PD3 pulled up.

Maybe this one?

10s pro Klipper config can be found here https://github.com/Desuuuu/DGUS-reloaded-Klipper-config

This is the cfg file from desuuu that I tried: https://github.com/Desuuuu/DGUS-reloaded-Klipper-config/blob/master/base/creality-cr10sprov2.cfg Had to comment out the last section. I guess it is related to the touch screen that desuuu made to work by forking klipper. I'm hesitant to move away from mainstream bc it could get stale. But then again I didn't spend enough time on it, maybe it's the way to go! https://www.reddit.com/r/CR10/comments/qkjkqd/cr10s_pro_v2_klipper_config_file_with_oem_touch/ https://www.reddit.com/r/CR10/comments/ibckmm/klipper_with_support_for_the_cr10s_pro_touchscreen/

I have used desuu config file as a start-point https://github.com/Desuuuu/DGUS-reloaded-Klipper-config I had to tweak it a bit to make bed leveling works correctly as klipper has changed how it handles the probe offset since it was originally released (i had to subtract my offsets from the max probe points in order to avoid out of boundaries errors since i have a huge offses on x due to hero me fan ducts).

Configuration for the stock Creality board for Klipper: https://github.com/Desuuuu/DGUS-reloaded-Klipper-config/blob/master/base/creality-ender5plus.cfg

i already tried to use just bl_touch config from cr-10s pro v2