DGUS-reloaded-Klipper-config Alternatives

DGUS-reloaded-Klipper-config reviews and mentions

• Flash Ender 5 to install Klipper
  3 projects | /r/klippers | 28 Jun 2023
• Sonic Pad with CR10s pro v1
  1 project | /r/CR10 | 8 Dec 2022

  I found https://github.com/Desuuuu/DGUS-reloaded-Klipper-config/blob/master/base/creality-cr10spro.cfg Does anyone know if this would work for my v1 pro?

• CR10s Pro v1 OctoPrint / Klipper BLTouch issues
  1 project | /r/CR10 | 1 Oct 2022

  I found This like that matches my setup and updated my printer.cfg so the sensor pin is mapped to PD3 pulled up.

• Need Firmware Please! CR10S Pro V1
  1 project | /r/CR10 | 26 Jun 2022
• CR-10S PRO (customized with BLTouch and Hemera). Should I move to Klipper from Marlin?
  2 projects | /r/klippers | 20 Jun 2022

  Maybe this one?

• Ayyyy, it's here! Going to set it up tomorrow
  2 projects | /r/CR10sPRO | 29 May 2022

  10s pro Klipper config can be found here https://github.com/Desuuuu/DGUS-reloaded-Klipper-config

• Firmware for CR10s Pro V2
  3 projects | /r/CR10 | 13 Feb 2022

  This is the cfg file from desuuu that I tried: https://github.com/Desuuuu/DGUS-reloaded-Klipper-config/blob/master/base/creality-cr10sprov2.cfg Had to comment out the last section. I guess it is related to the touch screen that desuuu made to work by forking klipper. I'm hesitant to move away from mainstream bc it could get stale. But then again I didn't spend enough time on it, maybe it's the way to go! https://www.reddit.com/r/CR10/comments/qkjkqd/cr10s_pro_v2_klipper_config_file_with_oem_touch/ https://www.reddit.com/r/CR10/comments/ibckmm/klipper_with_support_for_the_cr10s_pro_touchscreen/

• Help setting up PA
  1 project | /r/klippers | 21 Aug 2021

  I have used desuu config file as a start-point https://github.com/Desuuuu/DGUS-reloaded-Klipper-config I had to tweak it a bit to make bed leveling works correctly as klipper has changed how it handles the probe offset since it was originally released (i had to subtract my offsets from the max probe points in order to avoid out of boundaries errors since i have a huge offses on x due to hero me fan ducts).

• I want to try and Prusa-fy my Ender 5 Plus. Has anyone done something like this?
  4 projects | /r/ender5plus | 17 Apr 2021

  Configuration for the stock Creality board for Klipper: https://github.com/Desuuuu/DGUS-reloaded-Klipper-config/blob/master/base/creality-ender5plus.cfg

• Having difficulty configuring bltouch (cr-10s Pro v1)
  3 projects | /r/klippers | 24 Mar 2021

  i already tried to use just bl_touch config from cr-10s pro v2

• A note from our sponsor - SaaSHub
  www.saashub.com | 18 Apr 2025

  SaaSHub helps you find the best software and product alternatives Learn more →