Our great sponsors
-
InfluxDB
Power Real-Time Data Analytics at Scale. Get real-time insights from all types of time series data with InfluxDB. Ingest, query, and analyze billions of data points in real-time with unbounded cardinality.
Hi there, I've tried to install the Pluto IIx Board in my GC, sadly it doesnt send any picture. I first tried to use the Helder Quick Solder Flex Cable, after it didnt work I soldered every contact by cable. (which was good, since the Flex Cable put the Board in the wrong position anyway) The Pluto Board I got is from KNJN Item#6117 Pluto-IIx XC3S200A HDMI Preloaded with GCLoader 3.1. According to Documentation form KNJN the USB-C Boards come with a presoldered 100Ohm resistor for the DDC, hence I didnt wire in a resistor. HDMI Analog Adapter on a PC Monitor works fine, same monitor, same cable in the Pluto Board gives no signal. One of the LEDs is lit constantly and again, according to documentation by KNJN one LED should blink regularly if it is operating correct. Sadly I cant find anything on what "constantly lit LED" means. The GC is DOL-001(EUR) I soldered every cable according to this guide: https://github.com/ikorb/gcvideo/blob/main/HDL/gcvideo_dvi/README.md
Related posts
- Functionally-Complete Boolean Logic in Real DRAM Chips: Experimental Characterization and Analysis
- FPGA for Deep Learning: Survey and Future Directions
- Layout of Rust's u128 and i128 changed
- Finding the Right "Brain" and Software for Civilian Drone. Part 2
- Show HN: SatCat5, the open-source FPGA Ethernet switch