Our great sponsors
-
-
BIGTREETECH-SKR-mini-E3
BIGTREETECH SKR-mini-E3 motherboard is a ultra-quiet, low-power, high-quality 3D printing machine control board. It is launched by the 3D printing team of Shenzhen BIGTREE technology co., LTD. This board is specially tailored for Ender 3 printer, perfectly replacing the original Ender3 printer motherboard.
-
WorkOS
The modern identity platform for B2B SaaS. The APIs are flexible and easy-to-use, supporting authentication, user identity, and complex enterprise features like SSO and SCIM provisioning.
So I just got a BTT SKR Mini e3 v3.0 with STM32G0B1 and Im attempting to install Klipper with it. I used Kiuah on a raspberry pi 4, and installed everything I needed, then I created the firmware using the Klipper config on GitHub following the steps. I used WinSCP to get the firmware file, put it on an sd card, and tried to flash it, but was greeted with a blank blue screen on my Ender 3 Pro. In addition, I got the No MCU found error when trying to connect to it. I then attempted to use the premade Klipper firmware on the BTT GitHub, but that resulted in the same thing. Finally, I reflashed the Marlin Firmware and the printer booted up as normal with the screen working. Any help would be greatly appreciated!
So I just got a BTT SKR Mini e3 v3.0 with STM32G0B1 and Im attempting to install Klipper with it. I used Kiuah on a raspberry pi 4, and installed everything I needed, then I created the firmware using the Klipper config on GitHub following the steps. I used WinSCP to get the firmware file, put it on an sd card, and tried to flash it, but was greeted with a blank blue screen on my Ender 3 Pro. In addition, I got the No MCU found error when trying to connect to it. I then attempted to use the premade Klipper firmware on the BTT GitHub, but that resulted in the same thing. Finally, I reflashed the Marlin Firmware and the printer booted up as normal with the screen working. Any help would be greatly appreciated!