Wireshark VS esp_wifi_repeater

To begin with Wireshark, visit their official website for the download. The installation process is straightforward, but attention should be paid to the installation of command-line tools, which may require separate steps. Upon launching Wireshark, users are greeted with a selection of network interfaces as seen below. Choosing the correct interface, such as the loopback for local server debugging, is crucial for capturing relevant data.

Wireshark

If you're very curious as to what is really going on under the hood, I recommend you familiarize yourself with port mirroring for your switch platform of choice, and then use a laptop in promiscuous mode to capture traffic using Wireshark. Failing that, hire a network engineer to interview one of their sales engineers or architects, and have them explain it to you.

You should do a hands fins-on lab with Wireshark.

A great way to test the effectiveness of a pinning implementation is by simulating an MITM attack. Tools like Mitmproxy or Wireshack allow us to create a test environment to monitor, intercept, and proxy network requests for a test host.

They even have a nice comment explaining the heuristic: https://github.com/wireshark/wireshark/blob/ef9c79ae81b00a63...

     * Heuristics to detect the WireGuard protocol:

This has been put together for Wireshark, starting on line 1520 https://github.com/wireshark/wireshark/blob/master/epan/dissectors/packet-cip.c

Obviously based on the question you know the answer is a Wireshark-like software and it boils down to how you classify Wireshark. My issue is that Wikipedia refers to it as a Packet Analyzer, Varonis refers to it as a Packet Sniffer, Wireshark refers to itself as a Network Protocol Analyzer, Kali documentation refers to it as a Network Sniffer, Wireshark's README refers to itself as a Network Analyzer OR Sniffer...

esp32s and esp8266s are my favorite pieces of hardware... for $2 you can setup a wifi access point

https://github.com/martin-ger/esp_wifi_repeater

Have a look at one of the available WiFi repeaters (actually a WiFi NAT Router)

I'm trying to set up a wifi repeater using the binaries from https://github.com/martin-ger/esp_wifi_repeater. Flashing the software goes fine. Connects to internet fine. I set up the AP with a new name and password. Connecting to it seems fine but then it shows as connected, no internet. Any ideas?

Would something like this work? Connect to an ESP32 repeating the signal https://github.com/martin-ger/esp_wifi_repeater

I've never done an outdoor project but you'll need some waterproof strips and a sealed container for the mcu. You can buy waterproof strips in different led densities and styles from btf lighting in amazon and aliexpress, they are completely enclosed in a flexible plastic pipe (or hose?). Be careful with your maximum brightness since the leds can't dissipate as much heat. If they stay on during daylight you might lose many pixels. For the mcu I would use a small food container to which you can add extra waterproofing. If you need extra wifi range you can use an esp 8266 with this code on it https://github.com/martin-ger/esp_wifi_repeater

My mum has a portable WiFi device which is most time in her room, so the WiFi doesn't get to the living room and that's a problem but I love to solve problems so i did some googling and I found a GitHub repository for an ESP8266 repeater by martin-ger,the repo had a binary file for the repeater so I just flashed it into my esp8266 using esptool and it worked like magic. Click here to access the repository; however, there were some problems I had with this repeater(extender):