esp_wifi_repeater VS esp32_nat_router

esp32s and esp8266s are my favorite pieces of hardware... for $2 you can setup a wifi access point

https://github.com/martin-ger/esp_wifi_repeater

Have a look at one of the available WiFi repeaters (actually a WiFi NAT Router)

I'm trying to set up a wifi repeater using the binaries from https://github.com/martin-ger/esp_wifi_repeater. Flashing the software goes fine. Connects to internet fine. I set up the AP with a new name and password. Connecting to it seems fine but then it shows as connected, no internet. Any ideas?

Would something like this work? Connect to an ESP32 repeating the signal https://github.com/martin-ger/esp_wifi_repeater

I've never done an outdoor project but you'll need some waterproof strips and a sealed container for the mcu. You can buy waterproof strips in different led densities and styles from btf lighting in amazon and aliexpress, they are completely enclosed in a flexible plastic pipe (or hose?). Be careful with your maximum brightness since the leds can't dissipate as much heat. If they stay on during daylight you might lose many pixels. For the mcu I would use a small food container to which you can add extra waterproofing. If you need extra wifi range you can use an esp 8266 with this code on it https://github.com/martin-ger/esp_wifi_repeater

My mum has a portable WiFi device which is most time in her room, so the WiFi doesn't get to the living room and that's a problem but I love to solve problems so i did some googling and I found a GitHub repository for an ESP8266 repeater by martin-ger,the repo had a binary file for the repeater so I just flashed it into my esp8266 using esptool and it worked like magic. Click here to access the repository; however, there were some problems I had with this repeater(extender):

> No ESP could practically handle all that

You would be surprised what they can handle... See these examples:

https://github.com/ciniml/WireGuard-ESP32-Arduino

https://github.com/martin-ger/esp32_nat_router

Look at this to see how capable it is: https://github.com/martin-ger/esp32_nat_router

the esp-32 is a lot more capable then most people think..... see this for example: https://github.com/martin-ger/esp32_nat_router

Just thought of a way, but it's going to cost you another ESP32 controller. Set up a NAT router on a second controller. https://github.com/martin-ger/esp32_nat_router

Is there any library for ESP32 for creating NAT router using esp32 I have checked out https://github.com/martin-ger/esp32_nat_router but the issue is cannot use other libraries like GPIO or Shift along with it. I tried upload the basic blink sketch after loading the esp32 Nat router firmware but after that it is not working at all both the blink script and the Nat router.