tpotce VS pfSense

Have a look at tpot created by Deutsche Telekom. https://github.com/telekom-security/tpotce

After installing proxmox, I created a VM on it containing t-pot, an (.iso) packaged group of containerized honeypots with a compelling aggregation of logs, attack attempts, a heatmap showing attack/scan locations, ips, and numerous other criteria logged and viewable in pretty elasticsearch dashboards.

The Data for https://www.sicherheitstacho.eu/start/main comes from their Honeypot Software https://github.com/telekom-security/tpotce

As for blue team, there is tpotce which is a fully integrated Linux distro that deploys multiple honeypot containers and connects them back up into Elastic Search, but you'd need a device with 8GB+ RAM facing the internet unrestricted in a DMZ or something similar - https://github.com/telekom-security/tpotce

T-Pot - The All In One Honeypot Platform - T-Pot

I use it to run Splunk at home for testing. You can also run honeypots or use TPot.

Check this https://github.com/telekom-security/tpotce

If you want a live threat map/Honeypot and get a feel for what's attacking your network while also looking amazing, set up the T-pot - https://github.com/telekom-security/tpotce

One option is Firewalla Gold Plus, or you could buy a mini PC like it and run pfSense/OPNsense yourself.

Download and install pfsense as a virtual machine or partition: https://www.pfsense.org Configure it with the rules you want: https://youtu.be/VAGFGppSt74 Play with it, but be careful because it will block all traffic unless you check everything properly.

Another option is Firewalla, or buy a mini PC like it and run pfSense/OPNsense yourself. Two similar concepts, with the cost being either money or your DIY time. A lot of Firewalla users say that it's much easier for home use than pfSense/OPNsense, so you might find it worthwhile to spend a little more on it upfront and have to tinker less.

If you want firewall, I think you can use https://www.pfsense.org/ or https://opnsense.org/ , maybe running on an old PC or a Raspberry Pi. Not sure.

I've recently started using OPNsense. It's similar to pfSense, but seems to be considered a little more user-friendly.

For most router issues, I recommend people always put them in to dumb bridge mode and put a proper firewall like pfsense or opnsense as your gateway.

I have found that my historical average packet loss is about 0.02%. Something distinctly changed around 4/20 of this year, and now the average packet loss has gone up to 0.05% with spikes even higher, associated with periods of elevated ping times. It rarely did that before. Typically the IPv6 stack has more problems than v4 (especially an incident of packet loss on 4/28), and neither has been trouble-free since I started service in early 2020. My data comes from a pfSense installation.

I have done this using the Pfsense