pfSense VS core

One option is Firewalla Gold Plus, or you could buy a mini PC like it and run pfSense/OPNsense yourself.

Download and install pfsense as a virtual machine or partition: https://www.pfsense.org Configure it with the rules you want: https://youtu.be/VAGFGppSt74 Play with it, but be careful because it will block all traffic unless you check everything properly.

Another option is Firewalla, or buy a mini PC like it and run pfSense/OPNsense yourself. Two similar concepts, with the cost being either money or your DIY time. A lot of Firewalla users say that it's much easier for home use than pfSense/OPNsense, so you might find it worthwhile to spend a little more on it upfront and have to tinker less.

If you want firewall, I think you can use https://www.pfsense.org/ or https://opnsense.org/ , maybe running on an old PC or a Raspberry Pi. Not sure.

I've recently started using OPNsense. It's similar to pfSense, but seems to be considered a little more user-friendly.

For most router issues, I recommend people always put them in to dumb bridge mode and put a proper firewall like pfsense or opnsense as your gateway.

I have found that my historical average packet loss is about 0.02%. Something distinctly changed around 4/20 of this year, and now the average packet loss has gone up to 0.05% with spikes even higher, associated with periods of elevated ping times. It rarely did that before. Typically the IPv6 stack has more problems than v4 (especially an incident of packet loss on 4/28), and neither has been trouble-free since I started service in early 2020. My data comes from a pfSense installation.

I have done this using the Pfsense

dnsmasq can be used for wildcard domain aliases in OPNsense firewall, https://github.com/opnsense/core/issues/4145#issuecomment-12...

Firmware's like Asuswrt-Merlin or OpenWRT can support dynamic-dns, or you can do like I do and run something like OPNsense in an x86 VM with a NIC passed through, or buy an inexpensive firewall appliance (up to 500mbps/1gbps/10gbps).

The easiest solution is to buy your own router, set it up, disable the router functionality on the Fritzbox 7590 and plug your router into it. It'll be cheaper and easier than a Cisco Firewall, but if you want to go the dedicated firewall route then I would recommenced OPNsense

Much searching lead me to a possible patch Unbound.inc for how it was handling aliases for 23.7 -> https://github.com/opnsense/core/pull/5925

[2]: https://github.com/opnsense/core/issues/2544

BSDs may not have a significant presence on desktops, but they're well known in the networking world for their reliability. They also were the foundation used to build OSes for specific applications. OpnSense and XigmaNAS, for example, are two excellent FreeBSD based applications aimed at firewalling/security and NAS/services.

https://opnsense.org/

https://xigmanas.com/xnaswp/