operating-system VS room-assistant

https://github.com/home-assistant/operating-system/pull/3248

BTW found exact same issue with homeassistant browsing the internet; Add support for Intel GMAC Ethernet controller (#2589) (#2593) · home-assistant/operating-system@9ca836f (github.com)

HAOS (https://github.com/home-assistant/operating-system) is not "vanilla" linux, and I have somewhat little experience of linux, although using raspberry-based systems (Domoticz, Pihole, etc) and basic usage of unix mainframes since early 90s. But the question I could not find answer for by googling is, could I use HAOS to farm chia as well, or is it too much optimized towards HA usage to reasonably serve as a chia farming computer too?

The main issue with the 3A+ is the 512MB of RAM. Combined with only having one USB port and no Ethernet, I would not advise using a pi3A+ as a sustainable foundation for HA.

Home assistant was the last thing I had running as a VM, but recently switched over to running it in a LXC container with their ContainerOS (i think that's what they call it). I would say don't do it (at least not yet), and go with their full OS in a VM (dl link to correct KVM/qcow2 version). I say don't start with HomeAssistantContainer b/c you lose Supervisor and the add-on store, and it's a bit less straighforward to get installed.

One thing to notice, I have been able to successfully boot Home Assistant OS Generic x86-64 https://github.com/home-assistant/operating-system which is using kernel 5.15+ and I don't know why I am able to boot HAOS (maybe they are using uncompressed kernel?), but not other general or special Linux distributions.

Raspberry Pi 4 64-bit

hass.io builds the whole gamut of images. There's a list at the bottom of the github page https://github.com/home-assistant/operating-system/releases/tag/8.0.rc2

Also, I am using the bluetooth on the Pi to drive Room Assistant, to tell which room I'm in and automatically switch on the audio in that room when I am in that room, and switch it off when I leave. It also has support for the grid-eye sensor which looks like the flir sensor you useThere's also a similar project for ESP32 called ESPresence.

Check out Room Assistant. I have 9 RaspberryPi Zeros set up around my house and these do a great job tracking which rooms our cats are in, provided that we put a tiny BLE dongle on their collar.

Earlier I had six raspberry pi's spread around the house to try out new things (e.g. room level presence detection - which did not work well despite weeks of tuning - and as snapcast clients). But it became a pita to keep watch over so many independent systems, updating them, remembering the IP, passwords, forgetting what I have installed last time, etc. This is what I like with the whole docker thing: fire up a container, tweak it, and then if it is not used delete it again without affecting the other services.

There's a project called "room-assistant", however you'd need to have multiple Raspberry Pis running it in various locations...

https://www.room-assistant.io/

You can try room-assistant. It takes your Bluetooth devices and calculates distance, works quite nice in my environment for in room detection.

I've been playing around with room assistant. https://www.room-assistant.io/