octoprint_install VS obico-server

git clone https://github.com/paukstelis/octoprint_install.git.

I'm using an Inovato Quadra on my Ender 3 Pro. It was easy to setup with this script.

https://github.com/paukstelis/octoprint_install This is the installer script I used on my orange pi to set it up. Through the setup process it has you connect your webcam and set resolution and frame rate. Make sure you choose mjpg streamer vs ustreamer because Octolapse doesn't allow you to change camera settings if you choose ustreamer.

This script can help get Octoprint set up.

The guides I followed (this and this) both set the Octoprint service to autostart, so I can reboot from the browser or SSH or power cycle and Octoprint is active.

Should you have wanted to save yourself significant time, just could have just installed Debian and run the octoprint_install script: https://github.com/paukstelis/octoprint_install

Sorry, that's my bad. I'm running OctoPi on an old desktop, set up with Octoprint_Install: https://github.com/paukstelis/octoprint_install. The stream URL it gave by default is /cam_octoprint/?action=stream. Though while typing this comment, you did tip me off to something that actually fixed it! I was able to access my Octoprint instance with the Port 5000 URL, so never tried it without it. Once I deleted that port from the URL, I was able to access my Octoprint instance and the webcam stream is functioning! Thank you for your help!

Have a look at Obico, formerly known as the Spaghetti Detective (or is it a fork? I don't know).

https://github.com/TheSpaghettiDetective/obico-server https://www.obico.io/docs/server-guides/configure-octoprint-plugin/

Obico can pause prints when it detects they've failed (via a camera). If you have Octoprint, you can install it as a plugin.

The Obico team has created the Orange Pi Zero 2 for OctoPrint software to provide a way to easily install OctoPrint. We have tested the software with over 100 users and we are now making it available to everyone.

I wouldn't say that. As soon as we can see a justifiable interest, we (the obico team) hope to deliver a board with an easily installable image for OctoPrint, ideally using the raspberry pi imager, within a month or so.

Actually I’m a team member at Obico and have no affiliation with bambu except that I bought their printer.

It’s Obico’sAi failure detection meter watching for print failures.

The Spaghetti Detective - Monitors my 3D printer for print failures and, if a failure is detected, my print is automatically stopped