octoprint_install VS octoprint_deploy

git clone https://github.com/paukstelis/octoprint_install.git.

I'm using an Inovato Quadra on my Ender 3 Pro. It was easy to setup with this script.

https://github.com/paukstelis/octoprint_install This is the installer script I used on my orange pi to set it up. Through the setup process it has you connect your webcam and set resolution and frame rate. Make sure you choose mjpg streamer vs ustreamer because Octolapse doesn't allow you to change camera settings if you choose ustreamer.

This script can help get Octoprint set up.

The guides I followed (this and this) both set the Octoprint service to autostart, so I can reboot from the browser or SSH or power cycle and Octoprint is active.

Should you have wanted to save yourself significant time, just could have just installed Debian and run the octoprint_install script: https://github.com/paukstelis/octoprint_install

Sorry, that's my bad. I'm running OctoPi on an old desktop, set up with Octoprint_Install: https://github.com/paukstelis/octoprint_install. The stream URL it gave by default is /cam_octoprint/?action=stream. Though while typing this comment, you did tip me off to something that actually fixed it! I was able to access my Octoprint instance with the Port 5000 URL, so never tried it without it. Once I deleted that port from the URL, I was able to access my Octoprint instance and the webcam stream is functioning! Thank you for your help!

You DO NOT need to containerize OctoPrint. Docker adds quite a bit of unnecessary complication for multiple instances. I've made a tool that makes this very easy: https://github.com/paukstelis/octoprint_deploy

If your PC runs linux (superior) this is the way to achieve that: https://github.com/paukstelis/octoprint_deploy

I have installed it from https://github.com/paukstelis/octoprint_deploy. I will try the docker name for the dockers that are installed.

I've had a really good experience with octoprint deploy. https://github.com/paukstelis/octoprint_deploy

Docker containers are not necessary and mostly only add complications to using hardware. If you want multiple instances use the script I put together: https://github.com/paukstelis/octoprint_deploy

YUP, they are $35 right now on amazon. I just set my Potato up today and it runs great and its quick. I flashed armbian then used Octoprint deployand it was installed with just a few minutes! NICE.. I haven't printed anything yet, still adding plugins. But looks right so far.