architecture VS operating-system

It looks like Home Assistant refuses to add support for this.

Read here ha install

It’s all clearly defined in ADR-007 https://github.com/home-assistant/architecture/blob/master/a...

The TL;DR: Authentication for devices and services are via the UI only (to deal with OAuth2, refresh tokens, auto-updating IPs via mDNS). Automations/scripts/scenes are both YAML or UI.

Regular Docker installs are not unsupported. HA Supervised installs, if they don't meet the specific requirements, are unsupported.

Just make sure you follow the link at the top for the requirements and have all of the requirements insyalled before running the script.

A good write up / discussion was held on GitHub about this.

You can read more about it here.

Yes nest stream urls only last 5 minutes and we need to rearchitect streams https://github.com/home-assistant/architecture/issues/482

There is an architectural issue we're working through in https://github.com/home-assistant/architecture/issues/482 -- stay tuned. Once that is resolved, the "preload stream" checkbox will work to get it all ready before you open it.

https://github.com/home-assistant/operating-system/pull/3248

BTW found exact same issue with homeassistant browsing the internet; Add support for Intel GMAC Ethernet controller (#2589) (#2593) · home-assistant/operating-system@9ca836f (github.com)

HAOS (https://github.com/home-assistant/operating-system) is not "vanilla" linux, and I have somewhat little experience of linux, although using raspberry-based systems (Domoticz, Pihole, etc) and basic usage of unix mainframes since early 90s. But the question I could not find answer for by googling is, could I use HAOS to farm chia as well, or is it too much optimized towards HA usage to reasonably serve as a chia farming computer too?

The main issue with the 3A+ is the 512MB of RAM. Combined with only having one USB port and no Ethernet, I would not advise using a pi3A+ as a sustainable foundation for HA.

Home assistant was the last thing I had running as a VM, but recently switched over to running it in a LXC container with their ContainerOS (i think that's what they call it). I would say don't do it (at least not yet), and go with their full OS in a VM (dl link to correct KVM/qcow2 version). I say don't start with HomeAssistantContainer b/c you lose Supervisor and the add-on store, and it's a bit less straighforward to get installed.

One thing to notice, I have been able to successfully boot Home Assistant OS Generic x86-64 https://github.com/home-assistant/operating-system which is using kernel 5.15+ and I don't know why I am able to boot HAOS (maybe they are using uncompressed kernel?), but not other general or special Linux distributions.

Raspberry Pi 4 64-bit

hass.io builds the whole gamut of images. There's a list at the bottom of the github page https://github.com/home-assistant/operating-system/releases/tag/8.0.rc2