VoronUsers VS Voron-Switchwire

270º Clamping Hinges

Hotend is a Triangle Labs CHC Pro. Extruder setup is a mixture of a couple 😅 -mod of Mantis Toolhead to mount on MGN9C

Stealth skirts by Maverick

Those are a duct remix of this design, it is not yet posted since I need to install my wires to make sure no changes are needed. It will probably be uploaded in the next week.

I'm running a Chainflex umbilical cable + a beacon probe USB cable along the prebowden. I'm thinking about running the Bowden guide to help, I'm not pinching anything when I home the printer, but I'm looking to keep everything up and out of the way. https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/Galvanic/Bowden_Tube_Guide

Here is a good cfg to automate the fans

basically copied and pasted from here: VoronUsers/bedfans.cfg at master · VoronDesign/VoronUsers · GitHub with printer specific info bellow

Why don't you submit this to the vetted mods repository? https://github.com/voronDesign/voronusers

I swapped to these magnetic bottom panels and they are awesome!

I noticed that you mentioned being annoyed by the cable management (or lack of it) in the kit, which I think is probably not uncommon with many kits with some exceptions (LDO looks nice). That bothered me also, so I'm also working on something to help with cable management, which may also work with the Trident (a remix of these cable ducts).

I had my afterburner printhead_front (this part https://github.com/VoronDesign/Voron-Switchwire/blob/master/STL/Gantry/XZ_Axis/X_Carriage/Printheads/E3D_V6/printhead_front_e3dv6.stl) deform during warmup. Printer was preparing to print ABS and the toolhead also sat close to the bed.

Never had any major issues with overhangs, but I printed a Switchwire and I don't think it included the part pictured here. I did have a hell of a time with warping on the panel side-straps and front grills, and the settings above were what eventually carried me through.

link to the github https://github.com/VoronDesign/Voron-Switchwire (cad and STL's there)

The Voron Switchwire spool holder works just fine with an Ender 3 and its about as good as they get mate. https://github.com/VoronDesign/Voron-Switchwire/tree/master/STL you can find it here in the STLs section of the main repo.

Switchwire uses 20 tooth pulleys on all the motion motors so with 2mm belts that’s a rotation distance of 40 If you want an example of all the config parameters, check out the config file https://github.com/VoronDesign/Voron-Switchwire/blob/master/Firmware/skr_mini_e3_v2_config.cfg

However, it might be a little bit easier for you to use Ultrawaffle's Y carriage as it doesn't require you to drill out the stock carriage. With Ultrawaffle's Y carriage, you'll use the stock Switchwire Y motor mounts, Y idler assembly, and Y cable chain mounts which are located here