Voron-Switchwire VS VoronUsers

I had my afterburner printhead_front (this part https://github.com/VoronDesign/Voron-Switchwire/blob/master/STL/Gantry/XZ_Axis/X_Carriage/Printheads/E3D_V6/printhead_front_e3dv6.stl) deform during warmup. Printer was preparing to print ABS and the toolhead also sat close to the bed.

Never had any major issues with overhangs, but I printed a Switchwire and I don't think it included the part pictured here. I did have a hell of a time with warping on the panel side-straps and front grills, and the settings above were what eventually carried me through.

link to the github https://github.com/VoronDesign/Voron-Switchwire (cad and STL's there)

The Voron Switchwire spool holder works just fine with an Ender 3 and its about as good as they get mate. https://github.com/VoronDesign/Voron-Switchwire/tree/master/STL you can find it here in the STLs section of the main repo.

Switchwire uses 20 tooth pulleys on all the motion motors so with 2mm belts that’s a rotation distance of 40 If you want an example of all the config parameters, check out the config file https://github.com/VoronDesign/Voron-Switchwire/blob/master/Firmware/skr_mini_e3_v2_config.cfg

However, it might be a little bit easier for you to use Ultrawaffle's Y carriage as it doesn't require you to drill out the stock carriage. With Ultrawaffle's Y carriage, you'll use the stock Switchwire Y motor mounts, Y idler assembly, and Y cable chain mounts which are located here

Its the triano mod: https://github.com/walttriano/VoronUsers/tree/master/printer_mods/Triano/Ender_3Pro_Switchwire

I used this. But if I had to do it again I would've used this. Both contain build of materials.

One option to fix this involves taking the Voron Switchwire (Core XZ) route using either the Gizzle_switchwire) or Triano mods. Another recent development is this promising mod (but new and largely untested) that promises to do the same for real cheap.

There are two that i know of, the one i used is this one: https://github.com/walttriano/VoronUsers/tree/master/printer_mods/Triano/Ender_3Pro_Switchwire

Hey, see my other comment. As for the skirts, they're from Triano's ender 3 conversion mod, though I modified them a bit and then made them single-piece once my V2 was up.

This was once an Ender 3 Pro. I used DaRk_dOg's Mod of Trianos Ender>SW Mod. I still have a lot of tuning to do, but the next thing will be the enclosure :-)