Voron-Switchwire VS Enderwire_Docs

I had my afterburner printhead_front (this part https://github.com/VoronDesign/Voron-Switchwire/blob/master/STL/Gantry/XZ_Axis/X_Carriage/Printheads/E3D_V6/printhead_front_e3dv6.stl) deform during warmup. Printer was preparing to print ABS and the toolhead also sat close to the bed.

Never had any major issues with overhangs, but I printed a Switchwire and I don't think it included the part pictured here. I did have a hell of a time with warping on the panel side-straps and front grills, and the settings above were what eventually carried me through.

link to the github https://github.com/VoronDesign/Voron-Switchwire (cad and STL's there)

The Voron Switchwire spool holder works just fine with an Ender 3 and its about as good as they get mate. https://github.com/VoronDesign/Voron-Switchwire/tree/master/STL you can find it here in the STLs section of the main repo.

Switchwire uses 20 tooth pulleys on all the motion motors so with 2mm belts that’s a rotation distance of 40 If you want an example of all the config parameters, check out the config file https://github.com/VoronDesign/Voron-Switchwire/blob/master/Firmware/skr_mini_e3_v2_config.cfg

However, it might be a little bit easier for you to use Ultrawaffle's Y carriage as it doesn't require you to drill out the stock carriage. With Ultrawaffle's Y carriage, you'll use the stock Switchwire Y motor mounts, Y idler assembly, and Y cable chain mounts which are located here

Guide: https://github.com/RobotRogue/Enderwire_Docs

There's an unofficial work-in-progress BOM... https://github.com/RobotRogue/Enderwire_Docs/blob/main/README.md