VoronUsers VS Mini-AfterSherpa

270º Clamping Hinges

Hotend is a Triangle Labs CHC Pro. Extruder setup is a mixture of a couple 😅 -mod of Mantis Toolhead to mount on MGN9C

Stealth skirts by Maverick

Those are a duct remix of this design, it is not yet posted since I need to install my wires to make sure no changes are needed. It will probably be uploaded in the next week.

I'm running a Chainflex umbilical cable + a beacon probe USB cable along the prebowden. I'm thinking about running the Bowden guide to help, I'm not pinching anything when I home the printer, but I'm looking to keep everything up and out of the way. https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/Galvanic/Bowden_Tube_Guide

Here is a good cfg to automate the fans

basically copied and pasted from here: VoronUsers/bedfans.cfg at master · VoronDesign/VoronUsers · GitHub with printer specific info bellow

Why don't you submit this to the vetted mods repository? https://github.com/voronDesign/voronusers

I swapped to these magnetic bottom panels and they are awesome!

I noticed that you mentioned being annoyed by the cable management (or lack of it) in the kit, which I think is probably not uncommon with many kits with some exceptions (LDO looks nice). That bothered me also, so I'm also working on something to help with cable management, which may also work with the Trident (a remix of these cable ducts).

Does anyone have a mini-after-sherpa with a phaetus dragonfly 55W heater hotend config?

I printed a mini aftersherpa from the github and it says everything is 3010 and 3007 fans. There's also many different remixes, mods, adaptations, etc. of the mini-after-sherpa hotend fan-shroud thing...

There's this one which is popular but pretty much the same as stock just with the top cut off. https://github.com/PrintersForAnts/Mini-AfterSherpa

If you're dead set on changing things up, the two (relatively) minor mods I'd suggest are the Mini-AfterSherpa toolhead and ZeroPanels panel clips. These will save you from dealing with the hassle of assembling a Mini-AfterBurner (my least favorite thing about V0.1), and inserting a million captive nuts, respectively.

I used the mount from https://github.com/PrintersForAnts/Mini-AfterSherpa. It requires 5V, then the gpios on the pi. I ended up going with an MGN9C and mini sherpa. The weight seemed to cause a drop but didn't test after the MGN9C upgrade

Sherpa Mini Extruder from Fabreeko with 8GT motor and Mini Aftersherpa. I found this easier to service than the mini afterburner

MiniAfterSherpa Toolhead with Revo Micro

I'm not entirely sure I understand your question but https://github.com/PrintersForAnts/Mini-AfterSherpa might be the answer

In my opinion the Mini AB is terrible. I have the mosquito running with a Sherpa Mini extruder and cowling of my own design. But the mini after sherpa works ok. If you can't find another cowling that works, I could modify mine so it fits the larger mosquito. There are other designs out there like the V0VO

I did the AfterSherpa mod with a standard V6 and mini-Sherpa because: