SuperSlicer VS genius-firmware

I Would look into using SuperSlicer, a fork of PrusaSlicer

I suggest you temporarily (at least) use some print settings that are already excellent, start of with these). You need to install the official release of Superslicer. Find instructions on how to import the config bundle here.

Well, I doubt it's possible right now since the last release is already a few months old: Releases · supermerill/SuperSlicer (github.com)

There is a known issue where the config.ini contains the wrong version and Arachne is not visible. Check Issue 3094

I must have mis-remembered something, I thought there were a portable and installer version, however on the github download site the latest release, https://github.com/supermerill/SuperSlicer/releases/tag/2.4.58.5, only have one file for Windows which doesn't have an installer, this is the version i already use.

If you're a more advanced user then Super Slicer: https://github.com/supermerill/SuperSlicer/releases/tag/2.4.58.5

I'm not sure about specific settings, but I do have a slicer recommendation. SuperSlicer. It's a modified branch of PrusaSlicer that's basically just a better version of it

SuperSlicer

Having just slapped on a BL-touch i've recently swapped over to this until such time as i get round to embarking on Klipper https://github.com/jonathan-schmieg/genius-firmware.

When I tried to calibrate linear advance with this firmware and teaching techs gcode generator tool, the printer did weird things (I don't remember what it did because it was a few weeks back, but the gcode did not do what it was supposed to do). After that, multiple things stopped working. I found the pcb connector of the extruder slightly burned so I ordered a new one, which I now installed, with a new flat cable, but the extruder still doesn't move, but the hotend does heat up. X and Z movements work, but when I move Y, the printer gives an error message. The usb port also doesn't seem to work, the sd port does work. I also can't connect the printer to the computer with the usb b port, so I can't reflash it. Just before I tried the gcode, I printed a normal test cube, everything worked fine. I'm quite frustraded and pessimistic, but is it fixable without swapping the mainboard? If not, which one can you recommend? Thanks in advance!