Sovol-SV06-firmware VS klipper-sv06plus-screen

I followed this guide, skipped the installation step as the screen already comes with a Klipper installation. Removed everything inside /home/mks/printer_data/config and pulled the repo as instructed, but:

Anyone run into this? I sent an email to Sovol, waiting on a response, thought I'd ask here too to see if anyones run into this? Are the bed dimensions stored in the firmware somehow? Sorry not familiar with how this all works yet, wondering if I should try flashing this firmware https://github.com/bassamanator/Sovol-SV06-firmware/tree/sv06-plus

Did the install via https://github.com/bassamanator/Sovol-SV06-firmware and i am using the PrusaSlicer profiles from there.

I'm using a sovol sv06 plus converted to klipper with the files here https://github.com/bassamanator/Sovol-SV06-firmware

One-Stop-Shop Klipper Configuration

I tried to install klipper using this guide, but I used the releases page instead of downloading the tree for the SV06 plus, so I accidentally put sv06 firmware on my sv06 plus

Well the OSS currently supports any printer actually, so technically speaking, you can go ahead and install the OSS for your printer.

Which references this for partial KlipperScreen use of stock screen

My setup has been working great for the past three months and I don't believe that there are any issues with my acceleration values and velocity setting as I have been using them reliably since my initial setup. Recently however I attempted to get the stock screen that came with my SV06+ to work by following the guide outlined here “https://github.com/fryc88/klipper-sv06plus-screen”.

This makes the touch screen unusable but if you use https://github.com/fryc88/klipper-sv06plus-screen

I've had my SV01 Pro less than a month and I haven't even run 1kg of PETG (230°c) through it. My first prints were amazing direct from Cura to SD. I later set up Octoprint and the hits kept coming. I was delighted with my purchase. Then all of a sudden this week prints started to go awry, the smooth finish was a bit wonky at around 10mm height then at 40mm it started printing spaghetti, so I stopped the print. Gave it another go and it failed at around 3mm, tried less pieces and their failed at around 40mm, tried again and the last time, it was spaghetti after the first 5 layers or so. I'm thinking maybe my USB cable is bad and I intend to test that hypothesis by printing from SD. If the problem persists, what do you all suggest for troubleshooting. I'm not very octoprint savvy but my guess is that there should be logs I can comb through to check for communication errors, but I need your help to get the printer back into action. I was thinking maybe I could take advantage of the downtime and configure Klipper on it following this tutorial. https://github.com/fryc88/klipper-sv06plus-screen