OctoPrint-PrintTimeGenius VS OctoPrint-FirmwareUpdater

Bonus batch install popular addons: OctoPrint/bin/pip install "https://github.com/birkbjo/OctoPrint-Themeify/archive/master.zip" "https://github.com/jneilliii/OctoPrint-BedLevelVisualizer/archive/master.zip" "https://github.com/OctoPrint/OctoPrint-Autoselect/archive/master.zip" "https://github.com/MoonshineSG/OctoPrint-Autoscroll/archive/master.zip" "https://github.com/tpmullan/OctoPrint-DetailedProgress/archive/master.zip" "https://github.com/OllisGit/OctoPrint-DisplayLayerProgress/releases/latest/download/master.zip" "https://github.com/OctoPrint/OctoPrint-DisplayProgress/archive/master.zip" "https://github.com/OctoPrint/OctoPrint-FirmwareUpdater/archive/master.zip" "https://github.com/kantlivelong/OctoPrint-GCodeSystemCommands/archive/master.zip" "https://github.com/cesarvandevelde/OctoPrint-M73Progress/archive/master.zip" "https://github.com/cp2004/OctoPrint-EEPROM-Marlin/releases/latest/download/release.zip" "https://github.com/imrahil/OctoPrint-NavbarTemp/archive/master.zip" "https://github.com/jneilliii/OctoPrint-BLTouch/archive/master.zip" "https://github.com/eyal0/OctoPrint-PrintTimeGenius/archive/master.zip" "https://github.com/Salandora/octoprint-customControl/archive/master.zip" "https://github.com/j7126/OctoPrint-Dashboard/archive/master.zip"

I found a GitHub issue about this from 3 years ago, which states that you can remove a print from the print history (feature was added in a PR) but I can't find it anywhere in the interface.

For more accurate time prediction in OctoPrint, try the Print Time Genius plugin.

I use PrintTimeGenius for Octoprint. Seems good so far

After reading some more seems like you CAN do it, but I was either too scared or didn't know about it in Mid-2021

Firmware Updater Useful for flashing firmware to printer without having to use sd card. Frees up an sd card for me

I have 2 skr 1.4 turbo boards and before I switched to klipper I always updated my firmware using the firmware updater plug in for octoprint. On the github page it guided you through setup for that board family. https://plugins.octoprint.org/plugins/firmwareupdater/

I followed the install instructions from this link. I installed the python 3 compatible version of heat shrink.

Method 3 (Through Octopi) - I installed Anaconda to download the firmware updater for Octopi found here (https://plugins.octoprint.org/plugins/firmwareupdater/) but cannot install it through the command line. I get "python setup.py egg_info did not run successfully.". Tried upgrading pip to no avail.

if you have an Raspberry pi you can try https://plugins.octoprint.org/plugins/firmwareupdater/

I'm not sure if this OctoPrint plug-in works with the neptune 2 but it's worth a shot. https://plugins.octoprint.org/plugins/firmwareupdater/

You need a plugin called Firmware Updater.

Only if you already have Binary File Trainsfer setting enabled in Marlin. So you might be stuck since that's not normally enabled. But when it is enabled, it does work. I only update via octoprint anymore. https://github.com/OctoPrint/OctoPrint-FirmwareUpdater/blob/master/doc/marlinbft.md