Nevermore_Micro VS klipper-led_effect

I just built a Nevermore into my Voron 2.4. They have other models that you can check as well that fits other printers.

Nevermore Micro v6

Mind telling a bit more about nylon toxicity during printing? According to this: https://github.com/nevermore3d/Nevermore_Micro nylon emits caprolactam, which hasn't been found to be either toxic or not according to wikipedia.

Check out the shop links here https://github.com/nevermore3d/Nevermore_Micro

Trying to print the Nevermore filter. Doing the v5 duo XL.. this one

If you have a well sealed enclosure make or buy already printed from etsy NEVERMORE Filter then fill it with ONLY carbon that has NOT been acid washed.

Hello group. I have a question about neopixels. On my Marlin setup I defined Neopixel and Neopixel2. All LEDs ran off of the same pin. I was looking at this example. https://github.com/julianschill/klipper-led_effect/blob/master/docs/LED_Effect.md On this it shows 3 separate pins. So now I am confused. Can someone please explain to me how this works. I am just a beginner at this.

Neopixel Led’s: https://github.com/julianschill/klipper-led_effect

However, it is possible using klipper_led-effect

I'd suggest playing around with that until you feel like you are comfortable with it, and then if you want to start looking into animations and such you can check out klipper-led_effect. Just be warned (IMO) it's kind of confusing to configure.

These macros

LED Effects GitHUB

Yeah as a matter of fact klipper-led_effect literally just added this option yesterday.

Ok cool. What I'm trying to do is to add a Neopixel ring to the underside of my build plate (don't worry, I've already sorted out thermal insulation so they don't burn) and have it change colour automatically based off certain parameters. I want it white and breathing slowly when it turns on, changing from blue to red while it's heating and between 30⁰ and 60⁰, then breathing red while it prints. Finally it would turn green upon the print completing, and then go in reverse order from red to blue and back to white as the bed cools and lands below 30⁰. I've been researching this shit all day and have started to build a led_progress.cfg as instructed by this page, however, according to this page I can have all kinds of control over the lights.