Nevermore_Micro VS SW-magprobe

I just built a Nevermore into my Voron 2.4. They have other models that you can check as well that fits other printers.

Nevermore Micro v6

Mind telling a bit more about nylon toxicity during printing? According to this: https://github.com/nevermore3d/Nevermore_Micro nylon emits caprolactam, which hasn't been found to be either toxic or not according to wikipedia.

Check out the shop links here https://github.com/nevermore3d/Nevermore_Micro

Trying to print the Nevermore filter. Doing the v5 duo XL.. this one

If you have a well sealed enclosure make or buy already printed from etsy NEVERMORE Filter then fill it with ONLY carbon that has NOT been acid washed.

I use https://github.com/strayr/SW-magprobe on my switchwire which requires an endstop, but if you don't use a relative reference index, and don't set a mesh fade_target it will fade to the average height and you can swap between different buildplates without recalibrating. Amongst my collection is a fysetc buildplate that has a very thick and stiff spring steel layer beneath a smooth PEI sticker and very thin and floppy biqu powder coat, the mechanical probe can deal with swapping between these with ease

I found the inductive probe a bit vague and have installed an sw-magprobe, i had to modify that sightly, https://github.com/strayr/SW-magprobe, i'd recommend the switchwire klicky over it though and i'll be wiring for that when I add wires for stealthburner lights.