DWIN_T5UIC1_LCD VS Marlin

The screen doesn’t work by default unfortunately. There is a workaround to get it working. But I found that the default screen is redundant since I’m controlling everything through my laptop or my phone using the web interface. So I removed the original screen entirely

Klipper supports use of a screen. Even the stock Ender 3 screen can be used.

Original: https://github.com/odwdinc/DWIN_T5UIC1_LCD

For Moonraker: https://github.com/bustedlogic/DWIN_T5UIC1_LCD or this for Octoprint: https://github.com/odwdinc/DWIN_T5UIC1_LCD

if you’re using a rpi to run klipper you can kinda use it, https://github.com/odwdinc/DWIN_T5UIC1_LCD

I saw this project which seems to incorporate all of that by connecting the display directly to the pi, has anyone used this successfully?

i consider myself an intermediate linux/pi/etc user, as i can putz around, follow instructions, and usually fix my mistakes. now, i was curious if, through this method, would it be possible to use the included screen on the piboy and use the integrated controls?

I was looking around for how to get the V2's display working with klipper and Just found this: https://github.com/odwdinc/DWIN_T5UIC1_LCD

https://github.com/jyers/marlin/releases/ - Select E3V2-BLTouch-XxX-v4.2.X-v2.0.1.bin with X being either the amount of probing points or the version of your mainboard.

Couldn't tell you, but the Jyers firmware hasn't been updated since November 2021 according to the Github page: https://github.com/Jyers/Marlin

I glued 2 5p DuPont connectors back to back and put a red wire for vcc, a black wire for ground, a yellow wire for tx, and a green wire for rx (the colors are irrelevant, just for making sure the correct pins are connected to the pi) according to this schem: https://github.com/Jyers/Marlin/discussions/814

As it is a Creality board then Jyers might be better or even Mriscoc as it is more up to date.

Probably from there: https://github.com/Jyers/Marlin/discussions/814

I switched to Klipper long time ago, but even back then Creality FW was trash and Jyers was fw to use, but it's outdated now. I think most people use the "Profesional" fw now. It should not be hard to find guide on YT.