DIY-Multiprotocol-TX-Module VS opentx

have you heard of the "diy multiprotocol transmitter module" project? https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/

Looks like it's not supported yet: https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/issues/707

According to https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/blob/master/Protocols_Details.md the CC2500 RF chip *does* support the MJXQ protocol (used for the E010 sub-protocol).

You can look at all the available protocols here. Either way, I would highly recommend going with ExpressLRS rather than any of these protocols as it's much newer and higher performance.

4in1 Module, and control it via serial - https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/discussions/501

For reference, here's the list of supported protocols from the documentation: https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/blob/master/Protocols_Details.md

Yes. that Jumper T12 Pro is the one I have, and I highly recommend it! I personally had no problems with it at all, but I did have problems with the (much older) Jumper T16, but it seems they learned from their earlier mistakes and the T12 Pro was really perfectly fine for me. The reason I'm not using the T16 is that it's just so much bigger, and frankly the color screen seems like a nice idea (and it is), but it uses a lot of power (battery life) and is just harder to read is full sun light.All of thses transmitters (including FlySky) are some variation of "cheap chinese electronics", and the 'cheap' part is obviously the part we really like. The one problem I know of that it used to have was a software issue in OpenTX (related issues on Github #1 #2, if you're really curious). Basically, using voice output could stop it transmitting, which is obviously very bad (stuff falls out of the sky!), but has been fixed ages ago in OpenTX 2.3.8 (from about a year ago).

Oh man- that's way above my pay grade... I'm going to need some more experience before I can sort that out and it'll be a few days till I can even try since i'm travelling atm. Thanks so much for putting it together though! Pursuing it further- I had had made some progress on github. I loaded this config successfully onto my Taranis and yet I still don't know how to properly utilize it. Ahh well. I'll keep you posted if I ever succeed!