Get real-time insights from all types of time series data with InfluxDB. Ingest, query, and analyze billions of data points in real-time with unbounded cardinality. Learn more →
MKS-Robin-Nano-V3.X Alternatives
Similar projects and alternatives to MKS-Robin-Nano-V3.X
-
InfluxDB
Power Real-Time Data Analytics at Scale. Get real-time insights from all types of time series data with InfluxDB. Ingest, query, and analyze billions of data points in real-time with unbounded cardinality.
-
BIGTREETECH-SKR-mini-E3
BIGTREETECH SKR-mini-E3 motherboard is a ultra-quiet, low-power, high-quality 3D printing machine control board. It is launched by the 3D printing team of Shenzhen BIGTREE technology co., LTD. This board is specially tailored for Ender 3 printer, perfectly replacing the original Ender3 printer motherboard.
-
SaaSHub
SaaSHub - Software Alternatives and Reviews. SaaSHub helps you find the best software and product alternatives
MKS-Robin-Nano-V3.X reviews and mentions
-
I fried my board upgrading to 5015 fans. Would appreciate any advice on potential options
And, speaking of lacking, the MKS doesn't have a dedicated port for a neopixel. However, the MKS MINI12864 V3 uses a neopixel for lightning the screen, so you could use the EXP1/EXP2 ports, or use one of the UART ports as described here: https://github.com/makerbase-mks/MKS-Robin-Nano-V3.X/issues/7
-
Option 'exp1_1' is not valid in section 'board_pins'
LOOK AT https://github.com/makerbase-mks/MKS-Robin-Nano-V3.X/tree/main/hardware
-
klipper profile for sr
Robin Nano V3
-
Replaced my mobo with a BTT Octopus
Speaking of TMC drivers, you'll notice some pins beneath the spot where the TMC drivers plug in. You'll also get some jumper caps with your board. You WILL need to put some of these caps in. I didn't at first, and I found that telling the printer to move 100mm caused it to move 200mm. Here's why that happened: the printer was configured to expect the motors to use 16 microsteps. Now, let's look at the documentation on this page: https://github.com/makerbase-mks/MKS-Robin-Nano-V3.X/wiki/Drivers_MKS_TMC2209_2225_2208
-
Problem with mks robin nano on Anet A8
Hi, I have an Anet A8 with a mks robin nano v3.1 board installed. I wired up everything, installed the provided software but the dual Z axis won't home. I tried inverting the logic of the switch on the software but it didn't work. Basically if i manually close the switch the Z axis comes down without stopping.
-
Reprap firmware on STM32F104?
RRF is open source and it looks like a port for the Nano v3 might be in the works already: https://github.com/makerbase-mks/MKS-Robin-Nano-V3.X/issues/39
-
A note from our sponsor - InfluxDB
www.influxdata.com | 2 May 2024
Stats
makerbase-mks/MKS-Robin-Nano-V3.X is an open source project licensed under GNU General Public License v3.0 only which is an OSI approved license.
Sponsored