ESC-calibration Alternatives
Similar projects and alternatives to ESC-calibration based on common topics and language
-
ESP32_ISR_Servo
Discontinued This library enables you to use 1 Hardware Timer on ESP32-based board to control 16 or more servo motors. Now supporting ESP32, ESP32_S2, ESP32_S3, ESP32_C3-based boards. Tested OK with ESP32 core v2.0.5
-
InfluxDB
Power Real-Time Data Analytics at Scale. Get real-time insights from all types of time series data with InfluxDB. Ingest, query, and analyze billions of data points in real-time with unbounded cardinality.
-
Marlin
Marlin is an optimized firmware for RepRap 3D printers based on the Arduino platform. Many commercial 3D printers come with Marlin installed. Check with your vendor if you need source code for your specific machine.
-
SaaSHub
SaaSHub - Software Alternatives and Reviews. SaaSHub helps you find the best software and product alternatives
ESC-calibration reviews and mentions
-
Thrust issues. Not enough thrust? Where to begin checking?
Dochorahan, posted this on behalf of me, cause my post was being removed by the filter. As for your question. Following is the setup used for measuring the thrust. There is about 5cm gap from the base plate of weighing scale. The ESC is from a chinese manufacturer and it didnt came with any code so i used this one Code. When i used this code, at no load the rpm was 14100 for 11.5-12V Lipo on full throttle.
Stats
lobodol/ESC-calibration is an open source project licensed under MIT License which is an OSI approved license.
The primary programming language of ESC-calibration is C++.
Sponsored