xpad VS btrfs-progs

Use Linux there you can install this: https://github.com/paroj/xpad works great, except that videos that you want to use as background have to be in webm or ogv and NOT mp4

I had to compile and install the latest xpad for 2.4 mode to work. https://github.com/paroj/xpad

However, xpad recently added support for the bluetooth version.

Now we're going to acquire the xpad files, and dkms to set it up. sudo pacman -S dkms && sudo git clone https://github.com/paroj/xpad.git /usr/src/xpad-0.4 && sudo dkms install -m xpad -v 0.4

That particular controller doesn't seem to be compatible with Linux, I found a note about it on the XPad driver (https://github.com/paroj/xpad/issues/232) showing that it doesn't work with XPad. Which means it likely also doesn't work with XPadNeo, which Batocera uses.

I installed AntiMicroX and there all my buttons work. I also use this for driver - https://github.com/paroj/xpad

Googling I found a solution where you install an updated xpad , that has the ID for this 8bitdo controller added for it to recognize correctly. I tried installing it but fails stating that this kernel module is already installed, my only option is force install over it, but I got scared of effing up the xone/xpadneo that's working fine with the normal xbox bluetooth controller.

I'm pretty good with tech but I'm still relatively new to Linux, I was unable to find out what kernel SteamOS is built on or where to go from here. On a side note I know (https://github.com/paroj/xpad) exist and has support for the back paddles but it only works wired. Using a 10ft wire to play games on my couch completely defeats the point, I'd rather just play my deck on the couch at that point. If someone can point me in the right direction or help me get this working it'd be greatly appreciated.

Not an error I've seen before or that makes much sense to me at first glance, might want to take this to https://github.com/kdave/btrfs-progs/issues or the mailing list?

You can test it by allocating the space to see if it can use it all: e.g. fallocate -l 3.8t /mnt/elfstone2/butts should succeed. If it does, then it's probably fine even if the balance didn't do what it should have. If not and you run out of space with some unallocated space left on only one device, not so much. If its the same bug I saw that means if your fs was created pre kernel 5.19, it will not allocate correctly on >5.19 until the array is rebuilt under the newer kernel.

Mount options should be documented either at https://btrfs.readthedocs.io/en/latest/Administration.html or at the manual page section 5 (man 5 btrfs). Autodefrag is in section https://btrfs.readthedocs.io/en/latest/Administration.html#btrfs-specific-mount-options . In case you find more information missing, unclear, lacking cross-references please open an issue at https://github.com/kdave/btrfs-progs/issues .

thanks. I filled a feature request... https://github.com/kdave/btrfs-progs/issues/610

Resume sort of doesn't work, when you resumed it will have started a fresh balance with a high usage value (check your syslog to confirm).

That's the hint. It's an unfixed bug with the accounting when scrub is paused and resumed, the relevant issue is I think https://github.com/kdave/btrfs-progs/issues/227 .

[1] - https://github.com/kdave/btrfs-progs/issues/277

Hoping for a filesystem clone option at some point.