whopping_Voron_mods VS Voron-Hardware

Rainbow Barf SB LED Logo with Linneo Black LED diffuser

The bracket goes in the back like shown here

The mounts are the Whoppingpochard design.

I built a 300, and I can see the bi-metal extrusion warping without gantry backers that seems to be the biggest concern with going larger. (https://github.com/tanaes/whopping_Voron_mods/tree/main/extrusion_backers)

Insufficient heat soaking. As the chamber warms up the frame members deflect from thermal expansion, causing the toolhead to rise. In my experience you need a good hour or so with the doors closed for temperatures to stabilize enough, on a stock build. Putting backers on the Y rail extrusions can mitigate this as well: https://github.com/tanaes/whopping_Voron_mods/tree/main/extrusion_backers

Hello, the toolhead wiring may require few finishing touches. Ziptie those wires as close to the toolhead as possible, or use a wiring cover. If the stock one is small, you can use some of these for toolhead PCBs which are larger. https://github.com/craxoor/VoronMods/tree/master/PCB%20Cover https://github.com/VoronDesign/Voron-Hardware/tree/master/Afterburner_Toolhead_PCB/STLs/Clockwork/Covers

That would be this one https://github.com/VoronDesign/Voron-Hardware/tree/master/V0-Umbilical/

I'm trying to setup the V0 display on my V0.2 but I get an error when trying to flash klipper to it. I'm following this guide and it shows up correctly with 'lsusb' but at step 9 it gives me this error. Can anyone tell me what I'm doing wrong? I'm using the BTT Pi V1.2 and an SKR Pico.

Hello, please, is there any chance to tidy up the wiring on Afterburner toolhead a bit? I believe there should be a shorter standoff available for Afterburner toolhead PCB, and the PCB cover can be found here https://github.com/craxoor/VoronMods/tree/master/PCB%20Cover or here https://github.com/VoronDesign/Voron-Hardware/tree/master/Afterburner_Toolhead_PCB/STLs

Hello, the toolhead wiring could use few finishing touches ... any chance you could ziptie those wires a bit closer to the toolhead, or ven better put a wiring cover? If the default one is small, you can use for example this one for toolhead PCBs but it works well for Microfit connectors too https://github.com/craxoor/VoronMods/tree/master/PCB%20Cover or https://github.com/VoronDesign/Voron-Hardware/tree/master/Afterburner_Toolhead_PCB/STLs/Clockwork/Covers

Hi, yes you can as stated earlier by u/rgar132 Alternatively you can also get Klipper Expander, it's a small MCU which will provide few more connectors for various purposes. https://github.com/VoronDesign/Voron-Hardware/tree/master/Klipper_Expander I got mine from Ali if you do not have option to have it made by PCB manufacturer, but I am sure few vendors have those as well.

Firstly, on the guide: https://github.com/VoronDesign/Voron-Hardware/tree/master/Daylight it mentions that the sticks need 24v but on the PCB's it says that they are 5v (https://imgur.com/a/cl4vzjY) and im not sure what to go for here.

The toolhead wiring requires some finishing touches too. Ziptie those stray wires to the rest of the bundle, or hide those under cable cover. If the stock is too small, use one of the larger alternatives like this one or some of these.