wdisplays VS wdisplays

arandr replacement: wdisplays

Output/display configuration tool: kanshi, wdisplays, wlr-randr

... because I like quick, and lazy: https://github.com/cyclopsian/wdisplays

For an arandr replacement, https://github.com/swaywm/sway/wiki/i3-Migration-Guide recommends wdisplays.

But, Sway also supports a Wayland protocol which allows other applications to configure the displays instead. You can read it here if you want the gritty details. My preferred application to configure Sway's outputs is wdisplays.

Sway with wdisplays?

You could have a look at wdisplays. Uses wlroots.

I run 3 monitors in a similar config manually configured with negative x values for the left most monitor, it worked ok, but now I use https://github.com/artizirk/wdisplays for an easy life

wdisplays comes to mind.

sway laptop user here (for almost 2 years I think?).

I spent a little while on this, but I migrated from i3, so I just ported every little section of my config bit by bit.

In terms of battery bar and other "bar" type things, I use waybar[0] which basically does all the things you'd expect by default (just install and it "works").

For multi-monitor, config, I initially setup with wdisplays[1] (think arandr for wayland) and then manually copied the positions into my sway config. Monitor positioning was the only thing I needed to setup (and telling it that one monitor was HDPI) and then all of the scaling and everything worked perfectly. This was my biggest selling point for wayland, I now get nice crisp fonts and application scaling works nicely (which was not the case with X).

volume control from the keyboard took no time, just a couple of extra lines.

There was some stuff to do with the clipboard (wl-clipboard[2]) and screenshots (grim[3] + slurp[4]) that required some setup, but again, just a few lines, and didn't take much mental load.

Oh and I needed to change my notifications daemon(dunst[5]), and chose to change my program launcher to one with a nicer interface and cleaner fonts (wofi[6]).

I think that's all the tweaking that I did. Oh, and I needed to do something with pipewire to sort out screensharing at the start, don't remember that too well though...

[0] https://github.com/Alexays/Waybar

[1] https://github.com/artizirk/wdisplays

[2] https://github.com/bugaevc/wl-clipboard

[3] https://github.com/emersion/grim

[4] https://github.com/emersion/slurp

[5] https://github.com/dunst-project/dunst

[6] https://hg.sr.ht/~scoopta/wofi

Try wdisplays.