udp2raw VS SagerNet

Maybe udp2raw https://github.com/wangyu-/udp2raw

For that, I was going to setup UDP2RAW on my laptop to convert Wireguard's UDP traffic to TCP, send that TCP traffic to my server via port 22, to pretend it's SSH traffic, in the server setup UDP2RAW to convert that TCP back to UDP and send it to the Wireguard interface.

I've been doing some research and apparently, there's there are methods to obfuscate the VPN connection but everything I've looked at until now requires a special config on the server side of the VPN as well as the client side, and I haven't found anything related to Windscribes configuration for obfuscated servers via OpenVPN Scramble, Shadowsocks, obfsproxy, UDP2RAW, etc.

I read lots about this, e.g. the howto here. What I try to achieve is similiar to this setup here but the udp2raw server and client position should be switched. Is this possible somehow?

It's fair, though I would consider using tools like (for example) udp2raw for both OpenVPN and Wireguard if you need to bypass firewalls. Running OpenVPN in TCP mode is an awful experience.

Try to use udp2raw to hide the protocol https://github.com/wangyu-/udp2raw

check various ports with netcat as other mentioned. When you find a port you think may be open try it out. Additionally... this is all UDP and is EASILY blocked with deep packet inspection... you don't even need to go that deep into the packet... You could try a different VPN, or you could try to wrap your WireGuard into a TCP stream : https://github.com/wangyu-/udp2raw

If you cannot force proxy-obedient webview, you can use VPN tunnels. Just spilt-tunnel VPN and only tunnel traffic from a app to the proxy. For example, sagernet use a VPN tunnel implementation to force all traffic through a proxy. We may use this to force all android webview traffic or some other user-selected browser traffic to the proxy, routing through the i2p network. Just don't by-default setup outproxy. Either block non-i2p traffic outright, or route non-i2p traffic to clearnet. We could also use UPNP to port-forward automatically, and speed-test the user and enable a higher bandwidth by default. This way the i2p network can get more high-speed peers.

NaïveProxy Plugin - SagerNet (version 108.0.5359.94-1): The universal proxy toolchain for Android

安卓端 Sagarnet V2rayNG Clash android Windows端 Clash for windows Netch Winxray V2ray 等等产品线

You're right, I didn't think of that. Hmm, maybe you can use a proxy app (e.g. shadowsocks, sagernet, v2rayNG), but I don't have any experience with these.

Hello. I have several Wireguard configs (.conf) and want to test them before using one and find the best and fastest server. Also, most of them are periodically timeout and checking them one by one is so hard. I need a software that bulk tests them and shows me at least which is timeout. I find "Sagernet" app (https://github.com/SagerNet/SagerNet) that supports Wireguard protocol and three test methods (ICMPing TCPing URL test) But only ICMPing works for Wireguard that the results are not correct (for all servers shows a good ping while most of them are timeout). Is there a solution to the problem?

But i've found this app https://github.com/SagerNet/SagerNet. Supports many more protocols than Wireguard and socks5, but you can combine wg+socks5 with this app !! performance wise, i see no issues.

SagerNet (version 0.5-rc23): The universal proxy toolchain for Android