teslausb VS ipod-gadget

On the TeslaUSB page, it lists the following Raspberry Pi's as options:

Main difference between the two scenarios, however, is that the 3 was left in a parking garage, while the Y was left in an open field. With the 3 in a parking garage, I don't think the vehicle went over 100 degrees, while the Y, being left in an open field, would sometimes hit about 150 degrees. Because the temperatures were more reasonable in the parking garage, I also left my Raspberry Pi running TeslaUSB in the car, where as with the Y being left in an open field and being subject to extreme thermal temperatures, I opted to use a regular USB thumb drive there.

I've found that using something like TeslaUSB reduces the "blip" quite a bit.

This has had issues since the newer 2021 Intel-based model 3s (and I presume others). https://github.com/marcone/teslausb/issues/564

teslausb with a high endurance microSD card.

If you have a Raspberry Pi 0 or 4 you can do a TeslaUSB which let's yoy access the footage over a WiFi gotspot on the thing and a better WebUI.

If you've driven more than an hour since the incident, the footage will be gone (unless you're using TeslaUSB, but I'm guessing not)

I use this for my Teslas Dashcam (it was built for it), but it also has a feature to rsync music files from a network share every time it connects to the network. Sounds like it would cover what you want, and it supports RPI Zero Ws natively.

https://github.com/marcone/teslausb

Check this out: https://github.com/oandrew/ipod-gadget

It's a USB gadget kernel module that pretends to be an iPod to stream music to car/etc.

You may be able to, if rockbox implemented the iPod Gadget code it could work.

TL;DR: Would like to incorporate https://github.com/oandrew/ipod-gadget into my RPi car install. Have no idea how to get started. Any directions about what should be my next steps are very welcome!