strayr-k-macros VS klipper-prusa-mk3s

I use this macro to do square the gantry against the top frame You should only do this if you have adjustable current for your stepper drivers ([tmcxxxx] sections in your config for stepper_z and stepper_z1 drivers) You'll also want to make sure your stepper_z.position_max is just before the gantry would contact the frame.

I've added it into my LCD menu https://github.com/strayr/strayr-k-macros/blob/main/improved_menu.cfg, but beware, some of the menuitems pull in macros from other parts of the package. You may find the whole lot useful, read the docs. it needs some updating and perhaps the probe menu splitting into a standalone file.

I use u/strayr-k's macro for this: mechanical_level_tmc2209.cfg

I always use strayrr-k's mechanical gantry calibration macro to tram the gantry against the frame before using screws_tilt to level the bed.

Last note, the G34 macro I use is this one. Works really well on my dual Z setup (one driver for both steppers). I've noticed my Ender3 X gantry likes to set itself just a bit off-kilter when steppers are disabled, so I run a G34 at every startup to ensure it stays level as long as the motors are enabled.

you can try this https://github.com/strayr/strayr-k-macros/blob/main/M204.cfg but it can cause crashes if you have gcode with lots of accel changes, I encountered this on small mmu prints with lots of very short perimeters but it might be ok.

I use mech_gantry_cal.cfg a lot, but that only applies if you use dual z steppers and dual z drivers. This macro will bump the gantry against the z_max to straighten it against the frame and eliminate any drift between the drivers.

Prusa MK3S

I followed this guide and it mostly went flawlessly (had to manually download the repo as the automatic updater didn’t recognize it). With no tweaking everything works (probe, mesh bed, sensorless hone, filament runout sensor) and my test cube printed flawlessly without changing any slicer settings

Check out this repo https://github.com/dz0ny/klipper-prusa-mk3s

I know people who use klipper on the mk3. But I don't know how well it works with the probe and everything. https://github.com/dz0ny/klipper-prusa-mk3s