strayr-k-macros VS klipper-web-control-docker

I use this macro to do square the gantry against the top frame You should only do this if you have adjustable current for your stepper drivers ([tmcxxxx] sections in your config for stepper_z and stepper_z1 drivers) You'll also want to make sure your stepper_z.position_max is just before the gantry would contact the frame.

I've added it into my LCD menu https://github.com/strayr/strayr-k-macros/blob/main/improved_menu.cfg, but beware, some of the menuitems pull in macros from other parts of the package. You may find the whole lot useful, read the docs. it needs some updating and perhaps the probe menu splitting into a standalone file.

I use u/strayr-k's macro for this: mechanical_level_tmc2209.cfg

I always use strayrr-k's mechanical gantry calibration macro to tram the gantry against the frame before using screws_tilt to level the bed.

Last note, the G34 macro I use is this one. Works really well on my dual Z setup (one driver for both steppers). I've noticed my Ender3 X gantry likes to set itself just a bit off-kilter when steppers are disabled, so I run a G34 at every startup to ensure it stays level as long as the motors are enabled.

you can try this https://github.com/strayr/strayr-k-macros/blob/main/M204.cfg but it can cause crashes if you have gcode with lots of accel changes, I encountered this on small mmu prints with lots of very short perimeters but it might be ok.

I use mech_gantry_cal.cfg a lot, but that only applies if you use dual z steppers and dual z drivers. This macro will bump the gantry against the z_max to straighten it against the frame and eliminate any drift between the drivers.

git clone https://github.com/dimalo/klipper-web-control-docker.git klipper cd klipper docker compose up

I'm using a version of this repo: https://github.com/dimalo/klipper-web-control-docker

After searching on the Internet, I found one issue ticket mentioning this. https://github.com/dimalo/klipper-web-control-docker/issues/41

Hi! I've recently got an Intel NUC and decided to go klipper on fluidd. I used this guide. But unfortunately it didn't work, I'm getting the "mcu unable to connect" in fluid and the below logs in klipper. Any ideas?

This far all smooth. Now I am trying to install the fluidd and klipper on docker using https://github.com/dimalo/klipper-web-control-docker

I am trying to run the stack of Klipper/moonraker/Mainsail via docker. I found this and can get it running. My issue is that the various configs are not visible in the Mainsail interface. Does anyone have an idea or a different way to set up via docker?

If you don't want to use Debian based distro and you are okay with using either Moonsail or Fluidd, I recommend to use this docker image.

Here's what the dimalo container does: https://github.com/dimalo/klipper-web-control-docker/blob/main/klipper/Dockerfile

Here's my config, with all the unrelated macros removed. Apart from CHANGE_FILAMENT which I edited, all macros are pretty much untouched and come from here