stoiczfpv
FPV Drone Builds and Betaflight Configuration (by hectorsvill)
ExpressLRS-Hardware
STM32/ESP32/ESP8285-based High-Performance Radio Link for RC applications (by ExpressLRS)
| stoiczfpv | ExpressLRS-Hardware | |
|---|---|---|
| 1 | 5 | |
| 0 | 229 | |
| - | 6.6% | |
| 0.0 | 0.0 | |
| over 2 years ago | 6 months ago | |
| - | - |
The number of mentions indicates the total number of mentions that we've tracked plus the number of user suggested alternatives.
Stars - the number of stars that a project has on GitHub. Growth - month over month growth in stars.
Activity is a relative number indicating how actively a project is being developed. Recent commits have higher weight than older ones.
For example, an activity of 9.0 indicates that a project is amongst the top 10% of the most actively developed projects that we are tracking.
Stars - the number of stars that a project has on GitHub. Growth - month over month growth in stars.
Activity is a relative number indicating how actively a project is being developed. Recent commits have higher weight than older ones.
For example, an activity of 9.0 indicates that a project is amongst the top 10% of the most actively developed projects that we are tracking.
stoiczfpv
Posts with mentions or reviews of stoiczfpv.
We have used some of these posts to build our list of alternatives
and similar projects.
ExpressLRS-Hardware
Posts with mentions or reviews of ExpressLRS-Hardware.
We have used some of these posts to build our list of alternatives
and similar projects.
- ELRS DIY vs BUY
-
PCB with a 2.4GHz module and u.fl connector
I want to design a 2.4GHz ExpressLRS receiver and will use as reference open-sourced projects like this board.
-
jumper t lite internal elrs?
Here you go: ELRS module.
-
Using ELRS Happy Model ES24TX-Lite with X-Lite/ Pro
For those willing to semi DIY it (which most in this hobby are), here's my solution to getting X-Lite to accept HappyModel ES24TX-Lite. I 3d printed this case (https://github.com/ExpressLRS/ExpressLRS-Hardware/tree/master/PCB/2400MHz/TX_SX1280_Slimmer) You'll need to do a little modification after this is printed. You'll need to cut/break off the 2 post of the screws near the top of the module, this helps the module sit lower in the case. You'll also need to break off the back where the module pins will be. (attached image on google drive of what needs to be removed)https://drive.google.com/file/d/1P-rI2zjyh-zfX8_nWS-tvJQJicM86ICw/view?usp=sharing
- crossfire and ghost too
What are some alternatives?
When comparing stoiczfpv and ExpressLRS-Hardware you can also consider the following projects:
wfb-ng - WFB-NG - the next generation of long-range packet radio link based on raw WiFi radio
inav - INAV: Navigation-enabled flight control software
OpenHD - OpenHD
EmuFlight - EmuFlight is flight controller software (firmware) used to fly multi-rotor craft.