samoklava VS crkbd

Thanks! I should have been clear but I was talking about this project that's a fork of the main : https://github.com/soundmonster/samoklava

You might have to go down the path of making your own boards, I started off based on this: https://github.com/soundmonster/samoklava It's a good resource to minimize the amount of work you have to do on kicad

There’s only one autorouter that’s a) open source and b) known to work. It’s called FreeRouting. I’ve tried to adapt it for a GitHub workflow that takes an Ergogen YAML and outputs ready-for-fab PCB Gerber files. It doesn’t work perfectly for all use cases, so it’s probably worth double-checking the result with a DRC (design rule check) run in KiCad. Watch out for shorts and opens! 🤞

I used this Ergogen-based keyboard (samoklava), plus Chocorne's layout, as a basis for mine

There’s a board called ‘samoklava’ which is pretty corne-like , just with a bit wider thumb-splay and pinky-stagger https://github.com/soundmonster/samoklava

There is samoklava and rae-dux, and you can look through the layouts listed in this comparison tool for more. As for ones with a trackball, the Charybdis and its nano variant come to mind.

18 let half, wireless: https://github.com/soundmonster/samoklava

It's like completely generated and autorouted. Amazing. https://github.com/soundmonster/samoklava

Looks at the order here : https://github.com/foostan/crkbd/issues/96

I followed this guide for the build (https://github.com/foostan/crkbd/blob/main/corne-classic/doc/buildguide_en.md)

Not sure which information you mean, but here goes. Nice!Nano v2 Pinout (shows Arduino pin mapping). Nice!View Getting Started (explains how to remap the CS pin for a non-native shield like Corne). The overlay file where "cs-gpios" is set for the nice_view_adapter in ZMK. If you look at the Corne Schematic, you'll see as shown in the labels in this image that the bottom two pins (B2, B4, B5, B6) don't appear to be used for a column, row, or the OLED header. But the only way to really verify is to pull the KiCAD file for your Corne version and check yourself. I think D0 ("Data") should work. It appears to go to an optional I2C connection.

Want to say the corne board drawings etc are available at https://github.com/foostan/crkbd as well, if you fancy learning kicad you might be able to tweak them yourself ... though that is definitely the deep end of things...

https://youtu.be/-E7KRnVCjq8 https://youtu.be/4bB9A1YYyII https://github.com/foostan/crkbd/blob/main/corne-cherry/doc/v3/buildguide_en.md

For the layout, I took inspiration from the CRKBD and the Boardsource's Microdox.

This is the numbered LED series from the Corne Classic Build Guide (https://github.com/foostan/crkbd/blob/main/corne-classic/doc/buildguide_en.md)

I would need hex file from here https://github.com/foostan/crkbd/blob/main/doc/firmware_en.md and then i need to run flash command . Il read through it one more time, it seems that i use same hex file for both sides.