pfSense VS VideoLAN Client (VLC)

One option is Firewalla Gold Plus, or you could buy a mini PC like it and run pfSense/OPNsense yourself.

Download and install pfsense as a virtual machine or partition: https://www.pfsense.org Configure it with the rules you want: https://youtu.be/VAGFGppSt74 Play with it, but be careful because it will block all traffic unless you check everything properly.

Another option is Firewalla, or buy a mini PC like it and run pfSense/OPNsense yourself. Two similar concepts, with the cost being either money or your DIY time. A lot of Firewalla users say that it's much easier for home use than pfSense/OPNsense, so you might find it worthwhile to spend a little more on it upfront and have to tinker less.

If you want firewall, I think you can use https://www.pfsense.org/ or https://opnsense.org/ , maybe running on an old PC or a Raspberry Pi. Not sure.

I've recently started using OPNsense. It's similar to pfSense, but seems to be considered a little more user-friendly.

For most router issues, I recommend people always put them in to dumb bridge mode and put a proper firewall like pfsense or opnsense as your gateway.

I have found that my historical average packet loss is about 0.02%. Something distinctly changed around 4/20 of this year, and now the average packet loss has gone up to 0.05% with spikes even higher, associated with periods of elevated ping times. It rarely did that before. Typically the IPv6 stack has more problems than v4 (especially an incident of packet loss on 4/28), and neither has been trouble-free since I started service in early 2020. My data comes from a pfSense installation.

I have done this using the Pfsense

No. You can use a music player such as VLC Media Player to play music back tuned up or down slightly if you wish. But if people are affected by some frequencies and not others, that would be new.

I watched S1E01 using the AI-generated subs and they were surprisingly good! You just need to download both the sub file (.srt) and the raw video (.mkv) and watch it using a video player like VLC (https://www.videolan.org/vlc/). Subs and raw files at the links below thanks to u/MNLYYZYEG

VLC - Price: Free Free and open-source media player that plays most multimedia files and DVDs, Audio CDs, VCDs, and various streaming protocols. (UX/UI feels outdated imo)

It might be the media player you use. I recommend using VLC media player.

Seems to be C, not C++ to me. The C++ code is GUI wrappers to C++ GUI systems.

Hi there! Try with VLC or mpv players, and see if they can play the corrupted video.

Try the repair option in VLC media player.

You could try updating your LUA file with this: https://github.com/videolan/vlc/blob/master/share/lua/playlist/youtube.lua