pfSense VS OSSEC

One option is Firewalla Gold Plus, or you could buy a mini PC like it and run pfSense/OPNsense yourself.

Download and install pfsense as a virtual machine or partition: https://www.pfsense.org Configure it with the rules you want: https://youtu.be/VAGFGppSt74 Play with it, but be careful because it will block all traffic unless you check everything properly.

Another option is Firewalla, or buy a mini PC like it and run pfSense/OPNsense yourself. Two similar concepts, with the cost being either money or your DIY time. A lot of Firewalla users say that it's much easier for home use than pfSense/OPNsense, so you might find it worthwhile to spend a little more on it upfront and have to tinker less.

If you want firewall, I think you can use https://www.pfsense.org/ or https://opnsense.org/ , maybe running on an old PC or a Raspberry Pi. Not sure.

I've recently started using OPNsense. It's similar to pfSense, but seems to be considered a little more user-friendly.

For most router issues, I recommend people always put them in to dumb bridge mode and put a proper firewall like pfsense or opnsense as your gateway.

I have found that my historical average packet loss is about 0.02%. Something distinctly changed around 4/20 of this year, and now the average packet loss has gone up to 0.05% with spikes even higher, associated with periods of elevated ping times. It rarely did that before. Typically the IPv6 stack has more problems than v4 (especially an incident of packet loss on 4/28), and neither has been trouble-free since I started service in early 2020. My data comes from a pfSense installation.

I have done this using the Pfsense

Does the ossec system (www.ossec.net) not use ClamWin?

OSSEC: https://www.ossec.net/ HIDS

Hi there, as per title i am trying to use this script: https://github.com/ossec/ossec-hids/blob/master/active-response/cloudflare-ban.sh

OSSEC is good for monitoring logs, system files, etc. as well as alerting (and blocking traffic if you want) when anything suspicious happens

Takes a bit of work to set up but is worth it and includes lots of basic checks by default

https://www.ossec.net/

It's been a long time since I tried using OSSEC but maybe that would help. It's a Host-based IDS, rather than a network based IDS like Snort. Last time I checked you could point it towards your logs and it will parse them offline similar to how Snort can read a PCAP file.

Not sure if it could be considered one but maybe OSSEC Host Intrusion Detection System might get you some.of the way can be found here

WAZUH (fork of OSSEC would be my first choice when it comes to Linux based HIDS (host based), and Snort or Suricata if you are looking for NIDS (network based). As well as Lynis for ensuring the setup of the host is as you intended.