pfSense VS authelia

One option is Firewalla Gold Plus, or you could buy a mini PC like it and run pfSense/OPNsense yourself.

Download and install pfsense as a virtual machine or partition: https://www.pfsense.org Configure it with the rules you want: https://youtu.be/VAGFGppSt74 Play with it, but be careful because it will block all traffic unless you check everything properly.

Another option is Firewalla, or buy a mini PC like it and run pfSense/OPNsense yourself. Two similar concepts, with the cost being either money or your DIY time. A lot of Firewalla users say that it's much easier for home use than pfSense/OPNsense, so you might find it worthwhile to spend a little more on it upfront and have to tinker less.

If you want firewall, I think you can use https://www.pfsense.org/ or https://opnsense.org/ , maybe running on an old PC or a Raspberry Pi. Not sure.

I've recently started using OPNsense. It's similar to pfSense, but seems to be considered a little more user-friendly.

For most router issues, I recommend people always put them in to dumb bridge mode and put a proper firewall like pfsense or opnsense as your gateway.

I have found that my historical average packet loss is about 0.02%. Something distinctly changed around 4/20 of this year, and now the average packet loss has gone up to 0.05% with spikes even higher, associated with periods of elevated ping times. It rarely did that before. Typically the IPv6 stack has more problems than v4 (especially an incident of packet loss on 4/28), and neither has been trouble-free since I started service in early 2020. My data comes from a pfSense installation.

I have done this using the Pfsense

It's me and two others though I'm definitely the most active. We put a lot of effort into security best practices and one of my co-developers is currently reviewing the 4.38.0 release. It's a fairly major release with a lot of important code paths that have been improved for the future.

Our official docs can be found at https://www.authelia.com and you can find docs for a particular PR in the relevant PR. We've also linked the pre-release docs in the pre-release discussions which can be found here: https://github.com/authelia/authelia/discussions/categories/...

I use NGINX proxy with Authelia in between. Authelia blocks and blacklists faulty logins.

https://github.com/saltstack/salt https://github.com/chocolatey/choco https://github.com/nextcloud https://github.com/authelia/authelia https://github.com/grafana/grafana

If you are using HAProxy on PfSense/OPNSense, see my issue https://github.com/authelia/authelia/issues/2696

https://github.com/lldap/lldap is a very simple and lightweight LDAP solution. Works flawless with https://www.authelia.com/

Ah yeah, so I guess it's been a while since I tried and I forgot where I got stuck last time. Authelia's config.yml is absolutely massive and I'm not sure which section of their guide I should be following. In The Docker Compose section, there's "Unbundled", "Lite", and "Local". I think I want to be running the "lite" bundle, but their example compose file has a ton of Traefik stuff in it. I know I wouldn't keep the Traefik services, but do I need either secure or public?

Authelia supports SSO. If you are behind a reverse proxy it’s quite straightforward to integrate.

This should probably also be mentioned in the documentation so maybe consider mentioning this on their discussion page.